4. Setup
4. Setup
The initial setup procedure consists of:
•Configuring the computer’s network parameters and connecting the WiN7000 to the Web interface
•Verifying IP connectivity
4.1.Connecting the WiN7000 to the Web Interface
This section describes how to configure the network parameters in Microsoft Windows so you can connect a computer to the WiN7000 base station. For instructions on how to configure the network parameters for other operating systems, refer to your operating system documentation.
Before beginning, ensure that the base station is connected to the Power over Ethernet (PoE) power adaptor and that power is applied.
Follow these steps connect a computer to the WiN7000 web interface:
Procedure 4.1. Connecting a computer to the base station
1.Ensure that the PoE adaptor is connected to the base station. Connect the computer’s Ethernet port to the PoE adaptor’s Ethernet port.
2.On the computer, click Start and select Control Panel.
3.In the Control Panel, select Network and Internet Connections.
4.Select Network Connections and then
Figure 4.1. Microsoft Windows Local Area Connection Properties dialog box
5.In the Items list, select Internet Protocol (TCP/IP) and click the Properties button. The Internet Protocol (TCP/IP) Properties dialog appears.
6.Assign your computer the IP address 192.168.100.99 and the subnet 255.255.255.0.
RuggedCom® RuggedMAX WiN7000 | 26 | Installation Guide Rev1 |