3. Installation Procedures
3.6.2. SFD Type Base Station
The power system is supplied by the operator.
Connect the power system DC output to the RuggedCom cable with proprietary connector (supplied by RuggedCom).
Connect the other side (open end) of the RuggedCom cable to the operator’s power system (according to the labelling on the cable and the tables below.
RuggedCom Cable | Power Supply | Note |
GND | ||
|
|
|
+48VDC | +48VDC/ GND | “HOT Line” |
|
|
|
GND | Connect | |
|
|
|
Table 3.4. +48 VDC Power System |
|
|
RuggedCom Cable | Power Supply | Note |
“HOT Line” | ||
|
|
|
+48VDC | +48VDC/ GND | GND |
|
|
|
GND | +48VDC/ GND | Connect +48V and GND |
|
|
|
Table 3.5.
Figure 3.11, “Positive 48V Configuration”and Figure 3.12, “Negative 48V Configuration”show +48V and -48V configurations.
Figure 3.11. Positive 48V Configuration
Figure 3.12. Negative 48V Configuration
RuggedCom® RuggedMAX WiN7000 | 25 | Installation Guide Rev1 |