Symantec manual Enable all ports, Enable specific ports, ATCA-2210-Base# ATCA-2210-Fabric#

Installation Guide

Enable all ports

1. Verify you are at the applicable switch prompt.

Switch

Base Ethernet

Fabric Ethernet

Prompt

ATCA-2210-Base#

ATCA-2210-Fabric#

If you are not at the appropriate prompt, see View port status for instructions on how to get there.

2.Enter this series of commands to enable all ports.

A.configure

B.no shutdown all

C.spanning-tree port mode all

D.spanning-tree

E.exit

F.telnetcon timeout 60

G.copy system:running-config nvram:startup-config

This operation may take a few minutes. Management interfaces are not available during this time. When you are asked to save changes, enter y for yes or n for no. If you choose y for yes, this configuration is saved as the startup configuration.

Note: If the SCM includes the optional Procelerant™ CE3100 COM Express module, you may need to perform some additional port configuration procedures. See the ATCA-2210 Switch and Control Module Reference for more information.

3.Enter the exit command to return to the ATCA-2210#prompt.

4.Enter the exit command to log off the SCM.

5.If you have two SCMs installed, repeat these steps on the other SCM.

Enable specific ports

1. Verify you are at the applicable switch prompt.

Switch

Base Ethernet

Fabric Ethernet

Prompt

ATCA-2210-Base#

ATCA-2210-Fabric#

If you are not at the appropriate prompt, see View port status on page 7 for instructions on how to get there.

2.Follow these steps to enable specific ports:

A.Enter this command. configure

8