Symantec ATCA-2210 SCM installation checklist, Shelf After installation of the SCM, RadiSys shelf

Installation Guide

SCM installation checklist

The following table describes the possible installation scenarios for the SCM, the appropriate tasks to complete for the scenarios, and the order to complete the tasks:

SCM is being	Configuration	Tasks to complete and order to complete them
Installed in a RadiSys shelf	Standard configuration.	1.	Install the SCM in the shelf on page 5	____
		2.	Connect to the SCM on page 6	____
		3.	Verify switch operation on page 7	____
		4.	Verify shelf management operation on page 10	____
Installed in a non-RadiSys	Post-installation configuration required:	1.	Install the SCM in the shelf on page 5	____
shelf	After installation of the SCM in the	2.	Disable the Shelf Manager on the SCM on page 10	____
	non-RadiSys shelf, you must disable the
		3.	Verify switch operation on page 7	____
	SCM’s on-board Shelf Manager.
Removed from a non-RadiSys	Pre-removal configuration required:	1.	Enable the Shelf Manager on the SCM on page 12	____
shelf and reinstalled in a	Before you remove the SCM from the	2.	Remove the SCM from the non-RadiSys shelf. For
RadiSys shelf	non-RadiSys shelf, you must enable the
			SCM removal instructions, see the ATCA-2210 Switch
	SCM’s on-board Shelf Manager.
			and Control Reference.	____
		3.	Install the SCM in the shelf on page 5	____
		4.	Connect to the SCM on page 6	____
		5.	Verify switch operation on page 7	____
		6.	Verify shelf management operation on page 10	____

4