SUPER MICRO Computer 1.2b user manual Other, CD/Diskette Utilities, Dimensions

Page 16

X8DAH+/X8DAH+-F/X8DAH+(-F)-LR User's Manual

A PHY chip supports the Dedicated IPMI LAN (X8DAH+-F/(-LR) only) (Note 2)

One VGA Port supported by the Winbond WPCM 450R BMC Controller (X8DAH+-F/(-LR) only)

PS/2 mouse/keyboard ports, one COM port and one Serial header

Up to ten USB 2.0 (Universal Serial Bus) (six Backpanel USB Ports, and four Front Panel/Front Accessible USB connections)

Super I/O: Winbond W83627DHG

ALC888 Audio Controller supports 7.1 HD Audio with Line-in, Line-out and Microphone, Backpanel Audio and CD connections

Two Internal1394 headers

One EIDE Ultra DMA/100 bus master interface supports UDMA Mode 5 and PIO Mode 4

IPMI 2.0 with full KVM support (X8DAH+-F/(-LR) only) (Note 2)

Other

Console redirection

Onboard Fan Speed Control by Thermal Management via BIOS

CD/Diskette Utilities

BIOS flash upgrade utility and device drivers

Dimensions

Ext. ATX 13.68" (L) x 13.00" (W) (347.47 mm x 330.20 mm)

Note 1: For more information on SATA HostRAID configuration, please refer to the Intel SATA HostRAID User's Guide posted on our website @ http://www.supermicro.com/support/manuals/.

Note 2: For more information on IPMI configuration, please refer to the Embedded IPMI User's Guide posted on our website @ http://www.super- micro.com/support/manuals/.

1-8

Image 16
Contents X8DAH+ X8DAH+-F X8DAH+-LR X8DAH+-F-LR Page About this Manual About this Motherboard Manual OrganizationConventions Used in the Manual Contacting Supermicro HeadquartersEurope Asia-PacificTable of Contents Vii Bios IntroductionChecklist OverviewX8DAH+/X8DAH+-F/X8DAH+-F-LR Image Differences between X8DAH+/-F/-LR X8DAH+/X8DAH+-F/X8DAH+-F-LR LayoutYes Quick Reference Compact Flash Enabled Closed Enabled SMB to PCI/PCI-E Slots Open/Open DisabledVGA Enable Pins 1-2 Enabled X8DAH+-F/-LR only 1394-1/1394 Enable Pins 1-2 EnabledMemory Motherboard FeaturesChipset Acpi Features Expansion SlotsPC Health Monitoring Onboard I/OOther DimensionsCD/Diskette Utilities Introduction X8DAH+ System Diagram Block Diagram for the X8DAH+X8DAH+-F/-LR System Diagram Block Diagram for the X8DAH+-F/-LRChipset Overview Special Features PC Health MonitoringAcpi Features Slow Blinking LED for Suspend-State IndicatorMain Switch Override Mechanism System Resource AlertPower Supply Super I/OOverview of Winbond WPCM450 Controller For X8DAH+-F/-LR Only Page Installation Instructions Motherboard InstallationTools Needed Processor and Heatsink Installation Installing an LGA 1366 ProcessorSocket Clip Load Plate Plastic CapCPU Keys Load Plate Installing a CPU Heatsink Removing the Heatsink Dimm Installation Memory InstallationInstalling and Removing DIMMs Memory Support P1-DIMMs To Populate P1-DIMMs Branch P2-DIMMs To Populate P2-DIMMs BranchMemory Support for the Motherboard w/5500 CPUs Installed Memory Support for the Motherboard w/the 5600 CPUs Installed 35V DIMMs Possible System Memory Allocation & Availability TsegBack Panel Connectors/IO Ports Control Panel Connectors/IO PortsBack Panel Connectors Keyboard Purple Mouse Green ATX PS/2 Keyboard and PS/2 Mouse PortsPS/2 Keyboard/Mouse Pin Definitions Video Connector X8DAH+-F/-LR Serial PortsCOM VGA X8DAH+-F/-LR only Serial Ports-COM1/COM2 Pin DefinitionsBack Panel USB USB 0/1, 2~5 Universal Serial Bus USBFront Panel USB Pin Definitions USB6/7, 8/9 Ethernet Ports NC No ConnectionLAN2 LAN1 Ipmi LAN X8DAH+-F/-LR only LAN Ports Pin DefinitionCD &10-pin Audio Headers Back Panel High Definition Audio HD AudioHD Audio See the graphics above for details CD1 Pin Audio Power Button JF1 Header PinsFront Control Panel Front Control Panel Pin Definitions Power LEDNMI Button NIC1/NIC2 LED Indicators HDD LEDOverheat OH/Fan Fail LED Power Fail LEDOH/Fan Fail & UID LEDs B. PWR Supply Fail Reset Button Power ButtonReset Button Pin Definitions JF1 Power Button Pin Definitions JF1Connecting Cables Power ConnectorsRequired Pin ATX PWR Reqd B/C.8-pin Processor PWR ReqdFan Headers Chassis IntrusionFan 1 B. Fan Fan CPU1 Fan CPU2 Fan Chassis IntrusionInternal Speaker Power LED/SpeakerInternal Speaker Buzzer B. PWR LED/Speaker Ieee 1394a Connection Overheat LED/Fan Fail JOH1CNF1 1394a-1 CNF2 1394a-2System Management Bus Power SMB I2C ConnectorSMB Header Pin Definitions Jumper Settings Glan Enable/DisableEnabled Glan Port 1/2 EnableWatch Dog Enable/Disable Clear Cmos Watch Dog EnableWatch Dog Jumper Settings JWD Cmos ClearCompact Flash Enable I2C for PCI/PCI-E slots Jumper SettingsCompact Flash Card Enable Jumper Settings I2C Bus to PCI-Exp. SlotsVGA Enable X8DAH+-F/-LR Only 1394a-1/1394a-2 EnableVGA Enable 1394a EnableGlan LEDs Onboard LED IndicatorsIpmi Dedicated LAN LEDs X8DAH+- F/-LR BMC Heartbeat LED X8DAH+-F Onboard Power LEDOnboard PWR LED B. BMC Heartbeat LED Floppy Connector Floppy Drive, Serial ATA and SAS ConnectionsIDE Connector BaleSata 0~5 Serial ATA PortsSerial ATA Pin Definitions Before Power On Troubleshooting ProceduresNo Power Memory Errors Losing the System’s Setup ConfigurationNo Video Technical Support Procedures Frequently Asked QuestionsReturning Merchandise for Service Starting Bios Setup Utility IntroductionHow To Change the Configuration Data Main SetupStarting the Setup Utility System Time/System Date SuperMicro X8DAHProcessor System MemoryAdvanced Setup Configurations Boot FeaturePower Configuration Processor and Clock Options Active Processor Cores Intel AES-NI Available when supported by the OS and the CPUIntel Eist Technology CPU Bridge Configuration Advanced Chipset ControlMemory Mode QPI FrequencyQPI L0s and L1 Memory FrequencyNorth Bridge Configuration South Bridge Configuration IDE/SATA Configuration SATA#1 ConfigurationConfigure SATA#1 as SATA#2 ConfigurationLBA/Large Mode PIO ModePIO Mode Select Options Option Selected Max. Transfer Rate TypePCI/PnP Configuration PCI Latency Timer Boot Graphics Adapter PriorityPlug & Play OS PCI IDE BusMasterSuper IO Device Configuration Remote Access ConfigurationHardware Health Monitor CPU 1 Temperature/CPU 2 Temperature/System Temperature CPU 1 Temperature/CPU 2 TemperatureFan Speed Control Modes Fan Speed ReadingsVoltage Readings ACPI Configuration Trusted Computing IPMI Configuration View BMC System Event LogSet LAN Configuration Event Log Configuration Security Settings Supervisor PasswordUser Password Change Supervisor PasswordBoot Configuration Boot Device PriorityPassword Check Available when a password is installed Boot Sector Virus ProtectionHard Disk Drives Removable DrivesCD/DVD Drives USB DrivesExit Options Bios Error Beep Codes Bios Error Beep CodesBeep Code Error Message Description Page Appendix B Installing the Windows OS Installing the Windows OS to a RAID SystemInstalling the Windows OS to a Non-RAID System Installing Software Programs Driver/Tool Installation Display ScreenConfiguring Supero Doctor Supero Doctor III Interface Display Screen-II Remote Control