SUPER MICRO Computer X9SPV-F, X9SPV-LN4F Sgpio Headers T-SGPIO1/2, Overheat/Fan Fail LED JOH1

X9SPV Motherboard Series User's Manual

T-SGPIO Headers (T-SGPIO1/2)

The T-SGPIO1 and T-SGPIO2 (Serial-

Serial_Link-SGPIO

Pin Definitions

Link General Purpose Input/Output) headers are located near the SATA connectors on the motherboard. These headers are used to communicate with the enclosure management chip in the system. See the table on the right for pin definitions. Refer to the board layout

Pin#

1

3

5

7

Definition

NC

Ground

Load

Clock

Pin 2 4 6 8

Definition

NC

DATA Out

Ground

NC

below for the locations of the headers.

Overheat/Fan Fail LED (JOH1)

The JOH1 header is used to connect an LED to provide warnings of chassis over- heat. This LED will also blink to indicate a fan failure. Refer to the table on right for pin definitions.

Overheat LED

Pin Definitions

Pin# Definition

15vDC

2OH Active

OH/Fan Fail LED

Status Message

State	Message
Solid	Overheat
Blinking	Fan Fail

UID	JVGA1
MH4
LED2
X9SPV-F	U57
JPB1	JP1

VGA	JLAN2	JLAN1	J1	J3	JCOM1	COM1
						COM2
						JCOM2
					JPUSB1
	LAN2/4	LAN1/3
U21	U7	U10	U22			MH2

AT-SGPIO Headers

BOH/Fan Fail LED

T-SGPIO1

T-SGPIO2

MH6

JPI2C1

PWR I2C

JWP1:WRITE PROTECT

SP1

I-SATA5

I-SATA3

I-SATA1

U6
	U3
	JDIMM1
I-SATA4
	JDIMM2
I-SATA2
I-SATA0	JD1	LED1
		F6
	JTPM1:TPM/PORT80
JSD1:SATA
DOM POWER

B

U26

P1-DIMMA1

P1-DIMMB1

USB6/7

MH7

JPW1

A

2-20