SMC Networks 500082, HNC-63-INT manual Synergy MultiConnect SMC

Page 11

Rev 05

Synergy MultiConnect (SMC)

The Synergy MultiConnect (SMC) shown here is a required option to use the HNC-63-INT coil.

IMPORTANT: You must have the SMC device and Level 8.1.1 or higher software on your Intera system.

Additionally, Release 8.1.1 software requires a Synergy MultiConnect patch to enable this coil to be recognized by your system. Contact your Philips representative to receive this software patch. Software releases above 8.1.1 do not require the patch.

For more information on Synergy MultiConnect, please refer to Intera Release 8 Philips Application Guide/Volume 1 - Basics, Section 3.22.

The Synergy MultiConnect (SMC) is shown here with the HNC coil connector.

Image 11

Contents Rev Licenses and Trademarks Compatibility IntroductionGrasphere HNC Neurovascular Array CoilTable of Contents Training Quality Assurance Indications Contra- indications Patient SafetyPrecautions Emergency Procedures Technical Considerations Positioning the HNC-63-INT Coil on the Patient Table Array CoilPositioning Patient Synergy MultiConnect SMC Connecting Cable Right Side Patient Interface Control Unit Picu Left Side Patient Interface Control Unit PicuQuality Assurance MTC Rev Save raw data Yes Rev SNR Calulations Example SNR Calulations SNR Calulations Example SNR Calulations Head and Neck Imaging Selecting the Active Coil Scanning Set UpScanning Step by Step Scan Protocols Storage CleaningRev