SMC Networks HNC-63-INT, 500082 manual Connecting Cable

Page 12

Rev 05

Connecting

the Cable

Attach the Synergy MultiConnect (SMC) holder to the same side of the support as the patient ineterface control unit (PICU) facing the magnet. In this example, the PICU is on the left side. Slide the holder toward the bore, even with the patients knees.

For systems with PICU on left side of magnet, transfer SMC connector across table to the PICU. IMPORTANT: For SMC cable to reach PICU on left side of magnet, patient will need to be in position within the magnet, e.g., coil at magnet isocenter.

Route the coil cable and connector to the SMC holder, as shown above.

Join the SMC and HNC connectors, and place the assembly into the SMC holder, as shown above.

Landmark on the anatomy to be imaged and perform TRAVEL-TO-SCANPLANE.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Rev Licenses and Trademarks Introduction CompatibilityHNC Neurovascular Array Coil GrasphereTable of Contents Patient Safety PrecautionsTraining Quality Assurance Indications Contra- indications Emergency Procedures Technical Considerations Array Coil Positioning the HNC-63-INT Coil on the Patient TablePositioning Patient Synergy MultiConnect SMC Connecting Cable Left Side Patient Interface Control Unit Picu Right Side Patient Interface Control Unit PicuQuality Assurance MTC Rev Save raw data Yes Rev SNR Calulations Example SNR Calulations SNR Calulations Example SNR Calulations Scanning Set Up Head and Neck Imaging Selecting the Active CoilScanning Step by Step Scan Protocols Cleaning StorageRev
Top Page Image Contents