20 | Cheetah 4LP Installation Guide, Rev. B |
Initial setup information
The general information beginning on this page applies to all of the Cheetah 4LP drive models. After reading the general infor- mation topics, refer to the appropriate
Drive models | Page |
ST34501N | 39 |
ST34501W/WD | 43 |
ST34501WC/DC | 48 |
General information
The following general information topics are discussed:
•SCSI ID jumpers
•Drive termination
•Terminator power
•Interface drivers and data path width notes
•Other applicable jumper options
•Providing adequate cooling
•Mounting the drive and connecting cables1
•Formatting the drive
1This mounting procedure does not apply to “WC” or “DC” model drives. To mount a “WC” or “DC” drive, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.