Seagate ST34501WD, ST34501DC Electromagnetic compliance for the European Union, Australian C-Tick

Page 11

Cheetah 4LP Installation Guide, Rev. B

9

Electromagnetic compliance for the European Union

If this model has the CE Marking it complies with the European Union requirements of the Electromagnetic Compatibility Direc- tive 89/336/EEC of 03 May 1989 as amended by Directive 92/ 31/EEC of 28 April 1992 and Directive 93/68/EEC of 22 July 1993.

Australian C-Tick

If this model has the C-Tick Marking it complies with the Austra- lia/New Zealand Standard AS/NZS3548 1995 and meets the Electromagnetic Compatibility (EMC) Framework requirements of Australia’s Spectrum Management Agency (SMA).

Image 11

Contents ST34501N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 4LP Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 4LP Installation Guide, Rev. B Page Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionOnline services Seagate technical support servicesSeagate CompuServe forum SeaFAX FAX servicesSeagate technical support Direct-support servicesManufacturer’s representatives Customer service centersGeneral description Drive characteristics Additional drive characteristics +12V8 +5V8 Voltage regulation5 ± 5% ± 5%2 DC power requirements Amps ST34501 WC models WD, DC modelsDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Abbildung 4. Empfohlener Luftstromverlauf Suggested air flowInstallation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage Pin Gleichstrom Pin PowerHinweis Cheetah 4LP Installation Guide, Rev. B Mounting configuration dimensions Quick reference desktop system notes Formatting the driveSetting the Scsi ID on model N drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Jumper options Applicable jumper optionsDrive Active LED indicator connections Drive Active indicatorPage Page