Seagate ST34501N, ST34501WD, ST34501DC, ST34501WC manual Multiple-drive connection to host adapter

Page 29

Cheetah 4LP Installation Guide, Rev. B

27

“W” Model

“WD” Model

 

Drive

Drive

 

2 through X

SCSI devices [1]

SCSI ID 1

SCSI ID 0

Note:

Do not mix “W” and “WD” model drives [2] on the daisy

chain.

Terminator

Pin 1

(check your

adapter for Pin 1 location)

SCSI ID 7

Host Adapter

PCB

[1]“X” means up to 15 or the maximum allowable number of devices on the SCSI bus. See system documentation and Table 4.

[2]External terminator. Used only on end “WD” drive.

Figure 3d. Multiple-drive connection to host adapter

Image 29
Contents ST34501N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 4LP Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 4LP Installation Guide, Rev. B Page Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionOnline services Seagate technical support servicesSeagate CompuServe forum SeaFAX FAX servicesSeagate technical support Direct-support servicesManufacturer’s representatives Customer service centersGeneral description Drive characteristics Additional drive characteristics +12V8 +5V8 Voltage regulation5 ± 5% ± 5%2 DC power requirements Amps ST34501 WC models WD, DC modelsDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Abbildung 4. Empfohlener Luftstromverlauf Suggested air flowInstallation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage Pin Gleichstrom Pin PowerHinweis Cheetah 4LP Installation Guide, Rev. B Mounting configuration dimensions Quick reference desktop system notes Formatting the driveSetting the Scsi ID on model N drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Jumper options Applicable jumper optionsDrive Active LED indicator connections Drive Active indicatorPage Page