Seagate ST34501WD, ST34501DC, ST34501N Model W and WD drive alternate ID select and LED connection

Page 46

44

 

 

Cheetah 4LP Installation Guide, Rev. B

W/WD drives

 

 

 

 

 

68 Pin

 

 

 

SCSI I/O Connector

 

 

 

 

J1

Pin 1 J1A [2][4]

Pin 1

 

 

 

 

 

Pin 12

J1A Pin 1

SCSI Address A0

SCSI Address A1

SCSI Address A2

SCSI Address A3

No connection

+5V

Fault LED*

Vendor Unique*

Reserved

Activity LED*

Ground*

*These pins are driven low for 250 ms after PWR ON or RESET to allow jumper selectable SCSI ID as shown to the right.

4P

3P 2P

1P

J1-DC Power

SCSI ID = 0

SCSI ID = 1

SCSI ID = 2

SCSI ID = 3

SCSI ID = 4

SCSI ID = 5

SCSI ID = 6

SCSI ID = 7

SCSI ID = 8

SCSI ID = 9

SCSI ID = 10

SCSI ID = 11

SCSI ID = 12

SCSI ID = 13

SCSI ID = 14

SCSI ID = 15

Figure 12. Model “W” and “WD” drive alternate ID select and LED connection

Image 46
Contents ST34501N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 4LP Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 4LP Installation Guide, Rev. B Page Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance Electromagnetic compliance for the European Union Australian C-TickSeagate technical support services Online servicesSeagate CompuServe forum FAX services SeaFAXDirect-support services Seagate technical supportCustomer service centers Manufacturer’s representativesGeneral description Drive characteristics Additional drive characteristics DC power requirements Amps ST34501 WC models WD, DC models +12V8 +5V8 Voltage regulation5 ± 5% ± 5%2Dimensions of the drive Drive models General informationScsi ID jumpers Drive termination Terminator power Circuits and data path widthsCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener LuftstromverlaufMounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelPage Pin Power Pin GleichstromHinweis Cheetah 4LP Installation Guide, Rev. B Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on model N drivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Additional jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Applicable jumper options Jumper optionsDrive Active indicator Drive Active LED indicator connectionsPage Page