Seagate ST34501N, ST34501WD, ST34501DC, ST34501WC manual Electrostatic discharge protection

Page 4

2

Cheetah 4LP Installation Guide, Rev. B

Electrostatic discharge protection

Caution. Removal of circuit boards by personnel not perform- ing depot repair will damage components and may void the warranty.

All drive electronic assemblies are sensitive to static electricity, due to the electrostatically sensitive devices used within the drive circuitry. Although some devices such as metal-oxide semiconductors are extremely sensitive, all semiconductors, as well as some resistors and capacitors, may be damaged or degraded by exposure to static electricity.

Electrostatic damage to electronic devices may be caused by the direct discharge of a charged conductor or by exposure to the static fields surrounding charged objects. To avoid damaging drive electronic assemblies, observe the following precautions when installing or servicing the drive:

Ground yourself to the drive whenever the drive electronics are or will be exposed. Connect yourself to ground with a wrist strap (Seagate part number 12263496). Connection may be made to any grounded metal assembly. As a general rule, remember that you and the drive electronics must all be grounded to avoid potentially damaging static discharges.

Turn off the power before removing or installing the DC power cable.

Do not remove any circuit boards from the drive.

Never use an ohmmeter on any circuit boards.

When installing the drive on a carrier or tray, discharge the carrier or tray prior to inserting it into the system.

Image 4
Contents ST34501N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 4LP Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 4LP Installation Guide, Rev. B Page Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance Electromagnetic compliance for the European Union Australian C-TickSeagate technical support services Online servicesSeagate CompuServe forum FAX services SeaFAXDirect-support services Seagate technical supportCustomer service centers Manufacturer’s representativesGeneral description Drive characteristics Additional drive characteristics DC power requirements Amps ST34501 WC models WD, DC models +12V8 +5V8 Voltage regulation5 ± 5% ± 5%2Dimensions of the drive Drive models General informationScsi ID jumpers Drive termination Terminator power Circuits and data path widthsCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener LuftstromverlaufMounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelPage Pin Power Pin GleichstromHinweis Cheetah 4LP Installation Guide, Rev. B Mounting configuration dimensions Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers Setting the Scsi ID on model N drivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Additional jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Applicable jumper options Jumper optionsDrive Active indicator Drive Active LED indicator connectionsPage Page