Seagate ST34501WC, ST34501WD, ST34501DC, ST34501N manual Scsi ID jumpers

Page 23

Cheetah 4LP Installation Guide, Rev. B

21

SCSI ID jumpers

Each device on the SCSI chain must have a unique SCSI ID. The host system’s SCSI controller usually uses the ID that has the highest priority interrupt in the SCSI I/O system. This is always ID7. ID0 is lowest priority in an 8-bit I/O system. ID8 is lowest priority in a 16-bit I/O system. The lower priority SCSI IDs are normally used for other SCSI devices such as this Cheetah disc drive.

Note. Most SCSI controllers (host adapters) allow you to skip a SCSI ID. For example, you can have ID0, ID1, and ID3 (skipping ID2). Other controllers do not allow this so be sure to refer to your system or controller user’s manual for details about its requirements for proper SCSI device installation.

Note. This drive is a SCAM (SCSI Configured Auto Magically) compliant drive. If the system into which you are installing this drive requires SCAM compliant drives, you do not need to be concerned about the drive ID jumper settings, as the system automatically assigns your new drive the ID it wants it to have. The system may or may not use the existing drive ID jumper settings. Setting the drive ID doesn’t hurt anything, but is not necessary in a SCAM compliant system.

Most Cheetah disc drives are factory set with the SCSI ID set at

0.To change the SCSI ID, refer to the appropriate drive section for your model.

If, after completing the installation process, the drive’s LED does not show on/off activity when the host is trying to communicate with the drive, a duplicate SCSI ID may be the problem. If this is

Image 23

Contents ST34501N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 4LP Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 4LP Installation Guide, Rev. B Page Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionOnline services Seagate technical support servicesSeagate CompuServe forum SeaFAX FAX servicesSeagate technical support Direct-support servicesManufacturer’s representatives Customer service centersGeneral description Drive characteristics Additional drive characteristics +12V8 +5V8 Voltage regulation5 ± 5% ± 5%2 DC power requirements Amps ST34501 WC models WD, DC modelsDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Abbildung 4. Empfohlener Luftstromverlauf Suggested air flowInstallation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage Pin Gleichstrom Pin PowerHinweis Cheetah 4LP Installation Guide, Rev. B Mounting configuration dimensions Quick reference desktop system notes Formatting the driveSetting the Scsi ID on model N drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Jumper options Applicable jumper optionsDrive Active LED indicator connections Drive Active indicatorPage Page