Seagate 1270SL, 1080SL, 851SL, 540SL manual

Medalist SL Family Installation Guide, November 1995 17

4.Locate the bottom box on the screen. The model number of each drive EZ-Drive identifies is listed in this box. If a drive you have installed is not listed or the drive order (Drive 0 is the master, Drive 1 is the slave) is incorrect or there is a drive not identified message, make sure the master and slave jumpers are set correctly on the drives and the I/O and power cables are properly connected.

Note. Other troubleshooting tips are available in the Information Help menu.

Caution. Turn off your computer before resetting the jumpers or removing the cables.

5.If the drives are correctly identified, select Select Fully Auto- matic Installation in the Select Installation Type dialog box. This creates a single partition and formats the drive.

If you are installing the drive as Drive C, EZ-Drive automat- ically writes the system files to the drive to make it bootable.

6.When the format is complete, the Options dialog box appears. Select and read Important Information. This instruction tells you how retain the use of the EZ-Drive-installed drive when you boot to Drive A.

7.Select Reboot to reboot the computer and save the installa- tion. Remove the EZ-Drive diskette and put it away. It contains information about the drive setup.

Toward the end of the boot sequence, your screen should display a prompt for booting with a diskette followed quickly by the Micro House banner and the C: prompt. If the boot prompt and the banner fail to appear, your computer has not recognized the EZ-Drive installed drive. Retry the installation.