Seagate 851SL, 1080SL, 540SL, 1270SL manual

Page 29

Medalist SL Family Installation Guide, November 1995

27

 

 

 

BIOS’ setup test may be completing before the drive is ready.

One possible solution is to slow your computer’s processor speed during startup. If your computer has a turbo switch, set it to slow speed before turning the computer on. If there is no turbo switch, you may be able to use keyboard commands to slow the processor speed; see your computer manual for details. After the computer is up and running, return the processor to the fast speed.

Another solution is to warm-boot your computer after every power-on.

Check for I/O address conflicts. To isolate the conflict, first verify that the drive and host adapter are compatible with your computer by removing all the peripheral adapter cards (power must be off) except for the video card. Then reinstall the drive and host adapter card. If this is successful, reinstall the other peripherals one at a time until the conflict reoccurs.

After you have isolated the source of the address conflicts, you can resolve the conflict by changing the I/O address of the peripheral that appears to cause the conflict.

If your drive was installed with EZ-Drive, the special instruction in the boot sequence on Drive C may have been bypassed. Remove the diskette and reboot. The section “Booting with a diskette after EZ-Drive is installed” on page 18 describes how to boot with a diskette.

If the computer does not recognize the slave drive following power-on, the slave may not be communicating with the master during the boot cycle. Try reconfiguring the mas- ter/slave timing protocol jumpers discussed on page 8.

Image 29
Contents 540sl, 851sl 1080sl, 1270sl ATA Interface Drives Contents Introduction Drive features Model Before you begin Sicherheitsanleitung Required materials Configuring the driveDrive connectors Options jumper block settings Attaching the cables Attaching cables to the drive Attach a power-supply cable to the driveMounting holes Mounting the driveTransferring the software from the drive Type format a /s Configuring the computer Solutions for surpassing the 528-Mbyte barrier Determining whether your Bios accepts more than 528 MbytesUsing the EZ-Drive installation software Page Page Installing multiple partitions Booting with a diskette after EZ-Drive is installedPage Setup Standard setupTranslation geometry ModelPartitioning and formatting the drive Partitioning Low-level formattingHigh-level formatting Windows 32-bit disk accessPage Basic troubleshooting System does not recognize the drive Advanced troubleshootingPage Screen remains blank when you power up the system System error message, Drive not Ready, appears Drive does not format to full capacity Disabling EZ-Drive Required materials System error message, HDD controller failure, appearsDisabling Maximum Overdrive Page Location Modem number Technical support servicesSeaBOARD Location Telephone number SeaFAXSeagate Technical Support FAX /438-8137 SeaFONE /438-8222Seagate’s Internet connections SeaTDD /438-5382Seagate CompuServe forum Drive in an approved package Storing and shipping your drive
Related manuals
Manual 28 pages 14.67 Kb