Seagate 851SL, 1080SL, 540SL, 1270SL manual

Page 21

Medalist SL Family Installation Guide, November 1995

19

 

 

 

4.Select option 3 to delete the primary partition from the EZ- Drive installed drive.

Note. EZ-Drive puts a volume label on the partition it creates. You must enter the label name to delete the partition.

5.Repartition the drive in the partition sizes you want. Refer to your DOS manual if you need assistance creating partitions. Remember to make the Drive C primary partition active.

The computer will reboot when the partition process is complete. However, you must make sure the EZ-Drive installed drive is present to continue with the format. (The EZ-Drive banner ap- pears when the drive is recognized.)

1.Remove the diskette while the computer reboots. Press the CTRL key when the following message appears:

Hold the CTRL key down to boot from a floppy

The message is very quick and you may need to boot several times before you succeed. (Some computers allow you to press the CTRL key early.) If you get an Invalid OS error message, the computer has not found the EZ-Drive installed drive, and you must start the boot process again.

2.Reinsert the diskette.

3.Type format drive: for each partition you have created. drive represents the letter assigned to the partition.

Note. DOS automatically assigns a letter to each partition. Use the appropriate letter in the format statement.

If you are formatting Drive C, type format c: /s to make the drive bootable.

4.Reboot the computer when you are done formatting.

Image 21
Contents 540sl, 851sl 1080sl, 1270sl ATA Interface Drives Contents Introduction Drive features Model Before you begin Sicherheitsanleitung Required materials Configuring the driveDrive connectors Options jumper block settings Attaching the cables Attaching cables to the drive Attach a power-supply cable to the driveMounting holes Mounting the driveTransferring the software from the drive Type format a /s Configuring the computer Solutions for surpassing the 528-Mbyte barrier Determining whether your Bios accepts more than 528 MbytesUsing the EZ-Drive installation software Page Page Installing multiple partitions Booting with a diskette after EZ-Drive is installedPage Setup Standard setupTranslation geometry ModelPartitioning and formatting the drive Partitioning Low-level formattingHigh-level formatting Windows 32-bit disk accessPage Basic troubleshooting System does not recognize the drive Advanced troubleshootingPage Screen remains blank when you power up the system System error message, Drive not Ready, appears Drive does not format to full capacity Disabling EZ-Drive Required materials System error message, HDD controller failure, appearsDisabling Maximum Overdrive Page Technical support services SeaBOARDLocation Modem number Location Telephone number SeaFAXSeagate Technical Support FAX /438-8137 SeaFONE /438-8222SeaTDD /438-5382 Seagate CompuServe forumSeagate’s Internet connections Drive in an approved package Storing and shipping your drive
Related manuals
Manual 28 pages 14.67 Kb