Seagate 851SL, 1080SL, 540SL, 1270SL manual Options jumper block settings

Page 9

Medalist SL Family Installation Guide, November 1995	7

11 9 7 5 3 1

12 10 8 6 4 2

Circuit board side up

Spares

One drive only

Drive is master; slave is present

Drive is slave when another drive is master

Master/slave timing protocol. Drive waits up to 30 seconds for slave to respond.

Cable select

Remote LED connection

pin 11 (–), pin 12 (+)

Figure 2. Options jumper block settings

Image 9

Contents 540sl, 851sl 1080sl, 1270sl ATA Interface Drives Contents Introduction Drive features Model Before you begin Sicherheitsanleitung Required materials Configuring the driveDrive connectors Options jumper block settings Attaching the cables Attaching cables to the drive Attach a power-supply cable to the driveMounting holes Mounting the driveTransferring the software from the drive Type format a /s Configuring the computer Solutions for surpassing the 528-Mbyte barrier Determining whether your Bios accepts more than 528 MbytesUsing the EZ-Drive installation software Page Page Installing multiple partitions Booting with a diskette after EZ-Drive is installedPage Setup Standard setupTranslation geometry ModelPartitioning and formatting the drive Partitioning Low-level formattingHigh-level formatting Windows 32-bit disk accessPage Basic troubleshooting System does not recognize the drive Advanced troubleshootingPage Screen remains blank when you power up the system System error message, Drive not Ready, appears Drive does not format to full capacity Disabling EZ-Drive Required materials System error message, HDD controller failure, appearsDisabling Maximum Overdrive Page Technical support services SeaBOARDLocation Modem number Location Telephone number SeaFAXSeagate Technical Support FAX /438-8137 SeaFONE /438-8222SeaTDD /438-5382 Seagate CompuServe forumSeagate’s Internet connections Drive in an approved package Storing and shipping your drive

Related manuals

Manual 28 pages 14.67 Kb