Seagate 1270SL, 1080SL, 851SL, 540SL manual Partitioning and formatting the drive

Page 23

Medalist SL Family Installation Guide, November 1995

21

 

 

 

Select the user-defined or custom drive-type option, if avail- able, and enter your drive’s translation geometry.

If a user-defined drive type is not offered, select the drive type with the largest translation geometry. This is the maximum drive capacity your computer can recognize in its current configuration. To access the full capacity of your drive, you must upgrade your computer with a BIOS or host adapter capable of accessing more than 528 Mbytes.

Note. The drive does not use write precomp and landing zone. If these parameters are listed, make their values zero.

If you upgrade your system at a later date to achieve the drive’s full capacity, you must repartition and reformat the disc. Be sure to back up your data first.

5.When you have completed setting the translation geometry for your drive, save the values and exit System Setup. Reboot your computer. Partition and format the drive.

Partitioning and formatting the drive

Before you can use your Seagate drive, you must partition and format it. In this guide we discuss partitioning and formatting your drive with DOS—refer to your DOS user’s guide for assistance. If you are using another operating system, consult your operating system user’s guide for partitioning and formatting instructions.

Note. If you have not copied the free installation software to a diskette, your computer will detect a partition on the drive. You must erase this partition before you can access the full drive capacity. When you transfer the files to a diskette using Seamove (see page 11 for instructions), the partition is automatically erased when the transfer is complete.

Image 23
Contents 540sl, 851sl 1080sl, 1270sl ATA Interface Drives Contents Introduction Drive features Model Before you begin Sicherheitsanleitung Required materials Configuring the driveDrive connectors Options jumper block settings Attaching the cables Attaching cables to the drive Attach a power-supply cable to the driveMounting holes Mounting the driveTransferring the software from the drive Type format a /s Configuring the computer Solutions for surpassing the 528-Mbyte barrier Determining whether your Bios accepts more than 528 MbytesUsing the EZ-Drive installation software Page Page Installing multiple partitions Booting with a diskette after EZ-Drive is installedPage Model Standard setupSetup Translation geometryPartitioning and formatting the drive Partitioning Low-level formattingHigh-level formatting Windows 32-bit disk accessPage Basic troubleshooting System does not recognize the drive Advanced troubleshootingPage Screen remains blank when you power up the system System error message, Drive not Ready, appears Drive does not format to full capacity Disabling EZ-Drive Required materials System error message, HDD controller failure, appearsDisabling Maximum Overdrive Page Location Modem number Technical support servicesSeaBOARD SeaFONE /438-8222 SeaFAXLocation Telephone number Seagate Technical Support FAX /438-8137Seagate’s Internet connections SeaTDD /438-5382Seagate CompuServe forum Drive in an approved package Storing and shipping your drive
Related manuals
Manual 28 pages 14.67 Kb