Hawk 2XL Family Installation Guide, Rev. C | 11 |
_______________________________________________________________________________________________________________________
Caution. Note that the jumper plugs used on J2 are shaped differently and are smaller than those used on J6 or
The presence or absence of these jumper plugs in various places gives your drive information about how it is to operate in your system specifically. Each figure shows a diagram of one of these jumper headers, together with a brief description of the operational feature each jumper position controls.
If this is your first hard drive, or if it replaces your existing hard drive, you may not need to reposition any jumpers. However, check the figures against your drive to see if it is configured as it should be for your system. Consult your computer documen- tation for information on configuring your drive. Your dealer is the best source for help on this. Seagate also provides support service for customers if your dealer can't help.
Set Drive ID
Look at Figures 3a, 3b or 3c. If your new drive will be the only hard drive, assign it as "Drive ID 0," which requires no drive ID jumpers installed. If your new drive is to be a second hard drive, assign it as "Drive ID 1" by placing one of the extra jumper plugs supplied in the enclosed plastic bag (one of the larger plugs) on the "Drive ID 1" position, as shown in the figure. Do not remove cover from area shown shaded in the figure.
Double check drive ID settings for your drive or drives.