Direct mounting, Using drive rails | Seagate ST32151N/W/WC instruction

24Hawk 2XL Family Installation Guide, Rev. C

_______________________________________________________________________________________________________________________

pin 1 on the Seagate disc drive is the pin closest to the HDA, on the side closest to the four-pin powersupply con- nector as shown in Figure 4a or 4b. Plug the interface cable into the drive connector firmly but carefully. The connector should cover both rows of pins.

If you are installing a second or multiple disc drives, re- peat this procedure using the additional drive connectors on the interface cable, as shown in Figures 4c or 4d.

5.Mount the drive in a drive bay.

•Direct mounting:

The disc drive can be mounted in the drive bay in any orientation permitted by the drive bay mechanical con- figuration. Be careful not to over tighten the mounting screws. Screws must not extend into the side drive mounting holes more than 0.015 inches, (9/64 inches) or into the bottom mounting holes 0.20 inches (3/16 inches). Purchase the four required 6-32 x 1/4 inch screws at a hardware or drive supplier store. If needed, Figure 6 shows the drive mounting dimensions.

•Using drive rails:

In some computers, you must attach drive rails to either side of the drive, then slide the drive into the drive bay on its drive rails. Be sure that the drive is securely mounted within the bay. In computers that do not use drive rails, screw the drive or the frame kit holding the drive directly to the drive bay.