Things you may need to install the drive

Hawk 2XL Family Installation Guide, Rev. C

_______________________________________________________________________________________________________________________

You may find helpful the following booklet prepared by the FCC: How to Identify and Resolve Radio-Television Interference Problems. This booklet is available from the Superintendent of Documents, US Government Printing Office, Washington, DC 20402. Refer to publication number 004-000-00345-4.

Things you may need to install the drive

•Adequate power from your computer power supply This drive requires 7.5 watts during typical operation, and 6.0 watts when at idle (not reading, writing or seeking). If this drive is an "add-on" make sure the computer power supply can supply enough extra power for this drive's needs.

•An antistatic wrist strap

You will need this to reduce the possibility of damaging your drive by static discharge.

•A #2 Phillips screwdriver

You will need this screwdriver to open your computer and to insert the drive mounting screws.

•A Torx Size TX-08 driver tool

If your drive has a front panel and you need to install the drive in a conversion frame kit, this tool will be needed.

•A bootable DOS system diskette for the PC

You will need this diskette, which should contain the DOS system files and the programs FDISK.EXE and FORMAT.EXE to partition and format your new hard drive.