Seagate ST34311A, ST32112A, ST38421A, ST36421A manual Mounting screws

Medalist 8421, 6421, 4311 and 2112, Rev. A 7

Note.

!

If you are using the 80-conductor cable, attach the blue connector (with the longest section of the cable) to the motherboard, attach the black connector to the master or single drive, and attach the grey connector to the slave.

Caution. To avoid possible damage to your system, make sure to align pin 1 on the motherboard with pin 1 on your drive. Pin 1 on the interface cable is usually indicated by a stripe along the edge of the cable.

Figure 3. Mounting screws

3.You can mount the drive in any orientation. Usually it is mounted with the circuit board down.

4.Slide the drive carefully into the drive bay. Secure the drive with four 6-32 UNC mounting screws in either the side- mounting holes or the bottom-mounting holes. Insert the screws no more than 0.22 inch (5.58 mm) into the bottom- mounting holes and no more than 0.20 inch (5.0 mm) into the side-mounting holes.