Western Telematic IPS-800-D20, IPS-800E-D20, IPS-1600-D20, IPS-1600E-D20 Boot 1 or /BO Atmswtch

Operation

To Switch Plugs, or initiate a Boot Cycle, proceed as follows:

1.Switch Plug(s) On: To power-on a plug, type /ON n and press [Enter]. Where "n" is the number or name of the desired plug.

For example:

/ON 1 or /ON ROUTER

2.Switch Plug(s) Off: To power-off a plug, type /OFF n and press [Enter]. Where "n" is the number or name of the desired plug. Note that the "/OFF" command can also be entered as "/OF". For example:

/OFF 2 or /OF ROUTER

3.Boot Plug(s): To initiate a Boot cycle, type /BOOT n and press [Enter]. Where "n" is a the number or name of the desired plug. Note that the "/BOOT" command can also be entered as "/BO". For example:

/BOOT 1 or /BO ATMSWTCH

4.Set Plugs to Power Up Defaults: Type /D and press [Enter]. Plugs will be set to their default On/Off status, which is defined using the Plug Parameters Menu as described in Section 5.3.3.

Notes:

•When you have accessed command mode using the System Password, the Default command will be applied to all plugs.

•When you have accessed command mode using a Plug (User) Password, the Default command will only be applied to the plugs permitted by the password.

5.Suppress Command Confirmation Prompt: To execute a Boot/On/Off command without displaying the "Sure?" prompt, include the ",Y" option at the end of the command line. For example:

/ON ROUTER,Y or /BOOT 2,Y

6-5