Western Telematic IPS-800-D20, IPS-800E-D20, IPS-1600-D20, IPS-1600E-D20 manual Quick Start

3. Quick Start

This Quick Start Guide describes a simplified installation procedure for the IPS-800-D20, IPS-800E-D20, IPS-1600-D20 or IPS-1600E-D20 hardware, which will allow you to communicate with the unit in order to demonstrate basic features and check for proper operation.

Note that this Quick Start Guide does not provide a detailed description of unit configuration or discuss advanced operating features. For more information, please refer to the Installation, Configuration and Operation sections in this User's Guide.

3.1.Hardware Installation

3.1.1.Apply Power to the IPS

Refer to power rating nameplate on the IPS back panel, and then connect the unit to an appropriate power source. Note that the IPS features two separate AC inputs and two separate power busses; connect the power cables (supplied with the unit) to the unit's Circuit "A" and Circuit "B" Power Inlets, install the cable keepers, then connect the cables to an appropriate power source. Refer to the table below for information concerning power requirements and maximum loads.

Model	Total	Input	Max. Load	Max. Load	Max. Load
Number	Outlets	Voltage	per Outlet	per Bus	per Unit
IPS-800-D20	8	100 to	15 Amps	20 Amps	40 Amps
		120 VAC
IPS-800E-D20	8	100 to	15 Amps	20 Amps	40 Amps
		240 VAC
IPS-1600-D20	16	100 to	15 Amps	20 Amps	40 Amps
		120 VAC
IPS-1600E-D20	16	100 to	15 Amps	20 Amps	40 Amps
		240 VAC

Set the Main Power Switch in the ON position; the ON LED should light, and the RDY LED should begin to flash.

3-1