Western Telematic IPS-800-D20, IPS-800E-D20, IPS-1600-D20, IPS-1600E-D20 manual

Page 37

Conﬁ guration

Figure 5.14: Web Server Parameters Menu - Web Browser Interface

WEB SERVER:
1.	Service:	On
2.	Server Port #:	80

Enter Selection,

Press <ESC> to Exit ...

Figure 5.15: Web Server Parameters Menu - Text Interface

5.3.6.Web Server Parameters Menus

The Web Server Parameters Menus are used to conﬁgure the internal web server, which allows the unit to be operated via the Web Browser Interface.

•Web Browser Interface: Click the "Setup" button to access the conﬁguration menus, and then click the Web Server Parameters button. The Web Server Parameters Menu will be displayed as shown in Figure 5.14.

•Text Interface: Type /W and press [Enter]. The Web Server Parameters Menu will be displayed as shown in Figure 5.15.

The Web Server Parameters Menu allows you to deﬁne the following:

•Service: Enables/Disables the IPS’s Web Server. Note that when the Web Server is disabled, you will not be able to communicate via the Web Browser Interface. (Default = On.)

•Port Number: Sets the TCP/IP Port Number. The Port Number can be set to any valid number except 23; this is because 23 is the default port number that is used for communication with the unit via Telnet.

(Default = 80.)

5-19

Image 37

Contents Models User’s GuidePage Installation Instructions FCC Part 15 Regulation Table of Contents List of Figures Introduction Typographic Conventions IPS-800-D20, IPS-800E-D20, IPS-1600-D20 IPS-1600E-D20 UnitsIPS-800-D20 Back Panel 120 VAC Model Shown Unit DescriptionIPS-800/1600-D20 Series User’s Guide Apply Power to the IPS Hardware InstallationQuick Start Connect your PC to the IPS Communicating with the IPSText Interface Text Interface Type /X and press Enter Power Supply Connection InstallationInstalling the Cable Keepers IPS-800 Series Cable Keeper Installation Connection to Switched OutletsConnecting a Local PC Connecting the Network CableConnecting an External Modem Serial COM / RS232 Port ConnectionIPS-800/1600-D20 Series User’s Guide System Mode and User Mode ConfigurationPlug Status Screen Web Browser Interface IPS-800-D20 Shown Accessing the Web Browser InterfaceAccessing the Text Interface $ telnet 192.168.168.168 Enter Configuration Menus General Parameters Menu Web Browser Interface General Parameters MenusGeneral Parameters Menu Text Interface IPS-800/1600-D20 Series User’s Guide Serial Parameters Serial Parameters MenuIPS-800/1600-D20 Series User’s Guide Plug #1 Parameters Plug Parameters MenusPlug Passwords and Co-Location Features Reboot Cycles Network Parameters Menu Web Browser Interface Network Parameters Menus IP Security Feature Conﬁ guration 12 Telnet Parameters Menu Web Browser Interface Telnet Parameters Menus14 Web Server Parameters Menu Web Browser Interface Web Server Parameters MenusSave Configuration Parameters Operation via the Web Browser Interface OperationPlug Status Screen Web Browser Interface Plug Status Menu Web Browser Interface IPS-800-D20 Shown Plug Status Screen Text Interface Operation via the Text InterfaceIPS Help Screen Text Interface Switching and Reboot Commands Text InterfaceBoot 1 or /BO Atmswtch Applying Commands to Several Plugs Text Interface Logging Out of Command ModeAutomated Mode Manual Operation Sending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Upgrading the IPS Firmware IPS-800/1600-D20 Series User’s Guide Serial COM / RS232 Port Interface Interface DescriptionApx-1 Apx-2 SpecificationsApx-3 Customer ServiceApx-4 Trademark and Copyright InformationIndex-1 IndexIndex-2 Page Sterling Irvine California 949 586-9950 Toll Free