IPS-800/1600-D20 Series - User’s Guide
➂Bus "A" Switched Outlets and Indicator Lights: AC Outlets that can be switched On, Off or rebooted in response to user commands.
•
•
•
•
➃Bus "B" Switched Plugs and Plug Indicators: AC Outlets that can be switched On, Off or rebooted in response to user commands. Includes same components listed in item 3 above.
➄Default Button: This button can be used to either reset the unit to default parameters or manually toggle all plugs On or Off:
•Default Parameters: With the Main Power switch set in the Off position, press and hold the Default Button, then set the Main Power switch in the On position and release the Default Button. All menu defined parameters will be reset to default values.
•Manual Plug Toggle: Press the Default Button and hold it down for three seconds. All IPS power outlets will be toggled On or Off.
Note: If desired, the Default Button’s manual plug control capabilities can also be disabled as described in Section 5.3.1.
➅Unit Status Indicators: Two LED Indicators which function as follows:
•ON: Lights when power is applied to the IPS Unit.
•RDY: Flashes continuously when the IPS is ready to recieve commands.
➆Network Port and Activity Indicator: An RJ45 Ethernet Port for connection to your TCP/IP network. The default IP Address is 192.168.168.168, for more information, please refer to Section 5.3.4. The Activity Indicator flashes to indicate activity at the Network Port.
➇Main Power Switch: Applies power to the IPS Unit. This switch must be "On" in order for the IPS to function. Note that this switch is not used to set the On/Off status of the switched outlets.
➈COM / RS232 Port: A DB9, RS232 serial port (DTE), for connection to a local terminal or external modem, as described in Section 4.3.