Tyan Computer S2460 user manual Mode, Base I/O, Interrupt

(advanced setup, continued)

	FORMAT:	[option]
Mode	OPTIONS:	Normal	Selects the mode to use.
	NOTES:	This option is only for Serial Port B.
	FORMAT:	[option]
	OPTIONS:	3F8, 2F8	These options are depen-
Base I/O		3E8, 2E8	dent on the IRQ, and vice
			versa.
	NOTES:	Recommended combinations include ‘3F8,
		IRQ4’ and ‘2F8, IRQ3’.
	FORMAT:	[option]
	OPTIONS:	IRQ4	These IRQs are paired
Interrupt		IRQ3	with the Base I/O option.
	NOTES:	Recommended combinations include ‘3F8,
		IRQ4’ and ‘2F8, IRQ3’.
	FORMAT:	[option]
	OPTIONS:	Disabled	‘Disabled’ turns off the
			port.
		Enabled	‘Enabled’ requires you to
Parallel Port			enter the base I/O
			address and the INT num-
			ber.
		Auto	‘Auto’ makes the BIOS
			configure the port during
			POST.
	FORMAT:	[option]
	OPTIONS:	Output only	Standard one-way proto-
			col for parallel devices.
		Bi-directional	Two-way protocol for par-
			allel devices.
		EPP	Enhanced Parallel Port
Mode			interface may provide
			higher bandwidth, if an
			EPP device is used.
		ECP	Enhanced Capability Port
			interface may provide
			higher bandwidth, if an
			ECP device is used.
	FORMAT:	[option]
Base I/O	OPTIONS:	378	These options appear
		278	when the parallel port is
		3BC	set to ‘Enabled’.
	FORMAT:	[option]
Interrupt	OPTIONS:	IRQ5	These options appear
		IRQ7	when the parallel port is
			set to ‘Enabled’.

Tiger MP S2460

37