Tyan Computer TYAN S1572 ATX user manual Hardware Specifications/Features

Page 5

1.2 Hardware Specifications/Features

wCPU

Intel Pentium 75 MHz thru 200 MHz (Socket 7)

 

Intel Pentium P55C/P54CTB Overdrive (MMX)

 

Cyrix/IBM/SGS M1/6x86 P120+, P150+, P166+,

 

and AMD K5 PR90 through PR166.

wSpeed

50/60/66 MHz system bus

 

25/30/33 MHz PCI bus

wDRAM

3 banks of 72 pin SIMM and 2 DIMM sockets

 

Supports 5V or 3.3V memory

 

Supports EDO(Extended Data Out) DRAMs

 

Supports SDRAM(Synchronous DRAM)

 

Supports Fast Page Mode DRAMs

 

Supports 8MB to 256MB of DRAMs

wL2 Cache

512KB on board 2nd level cache memory

 

Supports pipeline-burst SRAM

wEIDE Controller

Primary and secondary PCI EIDE channels on

 

board for support of up to four EIDE Mode 0

 

through Mode 4 drives.

 

Supports DMA(Bus Master) mode 1 and 2.

 

( Bus Master driver on web at www.tyan.com)

 

Supports "UltraDMA/33" Synchronous mode.

wEnhanced I/O

Multi-mode bi-directional parallel port that

 

supports standard, EPP and ECP modes.

 

Supports 16550 compatible UARTS for on-board

 

high speed serial ports.

 

Support for an IrDA compliant Infra Red inter-

 

face.

 

On-board floppy controller

 

On-board Universal Serial Ports (2)

wI/O Bus Slots

5 Master/Slave PCI-Bus

 

3 ISA Bus One ISA and one PCI shared slot

wMouse

On-board PS/2 mouse connector.

S1572-001-01 http://www.tyan.com

5

 

 

 

 

 

 

 

 

 

Image 5
Contents Tyan S1572 ATX Page Table Of Contents Introduction Hardware Specifications/Features Environment Software SpecificationsBoard Installation CPU On Board Resource Setting .1 S1572 ATX Board LayoutDimm Memory Voltage Select 3V is Default CPU Speed Settings for Cyrix/SGS/IBM 6x86/M1/AMDHeatsink Fan Power J18 JP23 CPU SpeedCPU Select Default P54C, P55CMMX, & Cyrix Bios Voltage Select JP2 Default isCmos Reset JP1Default Battery On J8 Jumper Block DescFlash Eprom JP2 Reset Connector J8 pinKeylock Connector J25 Speaker Connector J8 pins Port Setting J15 and J16HDD LED J8 pins 13-14 and pins Infra Red Interface J8 pins 8-11 and J2Hardware Reset Switch Connector Installation Speaker Connector InstallationRefer to for Flash Eprom upgrade procedures Hardware Cmos & Password ResetDram Installation CPU Installation Upgrading Cache Memory Peripheral Device InstallationPress F1 to CONTINUE, CTRL-ALT-ESC or DEL to Enter Setup Entering SetupTo Enter Setup Before Boot Press CTRL-ALT- ESC or DEL KEY Control Keys Getting Help Main Menu Setup Page menu/Option Page Setup MenuWBIOS features setup WStandard Cmos setupWChipset features setup WPower Management setupTime Standard Cmos Setup MenuDate Drive a type/Drive B type Primary/Secondary Drive TypeEGA/VGA VideoHalt On MemoryOther Memory Expanded MemoryBoot Sequence Attempting to write to boot sector, continue? Y/NSwap Floppy Drive Default value is Disabled Virus warningGate A20 Option Boot Up Floppy SeekBoot Up NumLock Status Default value is On Video Bios Shadow Chipset Features SetupChipset Features Screen Security OptionWPower Management Power Management SetupWPM Control by APM WVideo Off MethodWReload Global Timer Events WDoze ModeWStandby Mode ROM ISA Bios PCI Slot Configuration Award SOFTWARE, INC PCI Slot ConfigurationWIRQ n assigned to WResources Controlled ByLegacy ISA PCI/ISA PnPIntegrated Peripherals Enter Password Load Setup defaultsPassword Disabled ROM ISA Bios Cmos Setup Utility Award SOFTWARE, INCIDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Flash Memory Writer Utility Screen AwardSystem Resource Timer MAPDMA Channels NMI