Tyan Computer TYAN S1572 ATX user manual

Page 2

Notice for the USA

Compliance Information Statement

( Declaration of Comformity Procedure) DoC

FCC Part 15: This Device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:

1)this device may not cause harmful interference, and

2)this device must accept any interference received including interference that may cause undesired operation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try one or more of the following measures:

wReorient or relocate the receiving antenna.

wIncrease the separation between the equipment and receiver.

wConnect the equipment into an outlet on a circuit different from that of the receiver connected.

wConsult the dealer or an experienced radio/TV technician for help.

Notice for Canada

This apparatus complies with the Class "B" limits for radio interference as specified in the Canadian Department of Communications Radio Interference Regulations.

Cet appareil est conforme aux normes de CLASSE "B" d' interference radio tel que spec' cifie' par le Ministe're Canadien des Communications dans les re'glements d'interfe'rence radio.

Notice for Europe (CE Mark)

This product is in conformity to the Council Directive 89/336/EEC, 92/31/EEC (EMC)

S1572-001-01 http://www.tyan.com

2

 

 

 

 

 

 

 

 

 

Image 2
Contents Tyan S1572 ATX Page Table Of Contents Introduction Hardware Specifications/Features Software Specifications EnvironmentBoard Installation On Board Resource Setting .1 S1572 ATX Board Layout CPUHeatsink Fan Power J18 CPU Speed Settings for Cyrix/SGS/IBM 6x86/M1/AMDDimm Memory Voltage Select 3V is Default JP23 CPU SpeedCmos Reset JP1Default Battery On Bios Voltage Select JP2 Default isCPU Select Default P54C, P55CMMX, & Cyrix J8 Jumper Block DescFlash Eprom JP2 Reset Connector J8 pinKeylock Connector J25 HDD LED J8 pins 13-14 and pins Port Setting J15 and J16Speaker Connector J8 pins Infra Red Interface J8 pins 8-11 and J2Speaker Connector Installation Hardware Reset Switch Connector InstallationHardware Cmos & Password Reset Refer to for Flash Eprom upgrade proceduresDram Installation CPU Installation Peripheral Device Installation Upgrading Cache MemoryPress F1 to CONTINUE, CTRL-ALT-ESC or DEL to Enter Setup Entering SetupTo Enter Setup Before Boot Press CTRL-ALT- ESC or DEL KEY Control Keys Setup Page menu/Option Page Setup Menu Getting Help Main MenuWChipset features setup WStandard Cmos setupWBIOS features setup WPower Management setupTime Standard Cmos Setup MenuDate Primary/Secondary Drive Type Drive a type/Drive B typeHalt On VideoEGA/VGA MemoryExpanded Memory Other MemorySwap Floppy Drive Default value is Disabled Attempting to write to boot sector, continue? Y/NBoot Sequence Virus warningGate A20 Option Boot Up Floppy SeekBoot Up NumLock Status Default value is On Chipset Features Screen Chipset Features SetupVideo Bios Shadow Security OptionWPM Control by APM Power Management SetupWPower Management WVideo Off MethodWReload Global Timer Events WDoze ModeWStandby Mode PCI Slot Configuration ROM ISA Bios PCI Slot Configuration Award SOFTWARE, INCLegacy ISA WResources Controlled ByWIRQ n assigned to PCI/ISA PnPIntegrated Peripherals Load Setup defaults Enter PasswordROM ISA Bios Cmos Setup Utility Award SOFTWARE, INC Password DisabledIDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Utility Screen Award Flash Memory WriterDMA Channels Timer MAPSystem Resource NMI