Tyan Computer TYAN S1572 ATX user manual Primary/Secondary Drive Type, Drive a type/Drive B type

Page 23

wPrimary/Secondary Drive Type

This category identifies the types of hard disk drives that have been in- stalled in the computer. There are 46 predefined types and a user definable type.

Press PgUp or PgDn to select a numbered hard disk type or type a number and press <Enter>. Note that the specifications of your drive must match with the drive table. The hard disk will not work properly if you enter improper information for this category. If your hard disk type is not listed, you can Type User to define your own drive manually.

If you select Type User, you will be asked to enter the following info. Enter the paramters directly from the keyboard and press <Enter>. The hard disk information should be provided in the documentation from the hard disk vendor or the system manufacturer.

CYLS

number of cylinders

HEADS

number of heads

PRECOMP

written precom

LANDZONE

landing zone

SECTORS

number of sectors

If a hard disk has not been installed or you have a CD-ROM/Tape drive connected to an IDE channel, select NONE and press <Enter>.

wDrive A type/Drive B type

This category identifies the types of floppy disk drive A or B, that have been installed in your computer.

None

No floppy drive installed

360K, 5.25 in.

5-1/4 inch PC-type standard drive; 360 kilobyte capacity

1.2M,5.25 in.

5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity

720K, 3.5 in.

3-1/2 inch double-sided drive; 720 kilobyte capacity

1.44M, 3.5 in.

3-1/2 inch double-sided drive; 1.44 megabyte capacity

2.88M, 3.5 in.

3-1/2 inch double-sided drive; 2.88 megabyte capacity

S1572-001-01 http://www.tyan.com

23

 

 

 

 

 

 

 

 

 

Image 23
Contents Tyan S1572 ATX Page Table Of Contents Introduction Hardware Specifications/Features Environment Software SpecificationsBoard Installation CPU On Board Resource Setting .1 S1572 ATX Board LayoutJP23 CPU Speed CPU Speed Settings for Cyrix/SGS/IBM 6x86/M1/AMDDimm Memory Voltage Select 3V is Default Heatsink Fan Power J18J8 Jumper Block Desc Bios Voltage Select JP2 Default isCPU Select Default P54C, P55CMMX, & Cyrix Cmos Reset JP1Default Battery OnFlash Eprom JP2 Reset Connector J8 pinKeylock Connector J25 Infra Red Interface J8 pins 8-11 and J2 Port Setting J15 and J16Speaker Connector J8 pins HDD LED J8 pins 13-14 and pinsHardware Reset Switch Connector Installation Speaker Connector InstallationRefer to for Flash Eprom upgrade procedures Hardware Cmos & Password ResetDram Installation CPU Installation Upgrading Cache Memory Peripheral Device InstallationPress F1 to CONTINUE, CTRL-ALT-ESC or DEL to Enter Setup Entering SetupTo Enter Setup Before Boot Press CTRL-ALT- ESC or DEL KEY Control Keys Getting Help Main Menu Setup Page menu/Option Page Setup MenuWPower Management setup WStandard Cmos setupWBIOS features setup WChipset features setupTime Standard Cmos Setup MenuDate Drive a type/Drive B type Primary/Secondary Drive TypeMemory VideoEGA/VGA Halt OnOther Memory Expanded MemoryVirus warning Attempting to write to boot sector, continue? Y/NBoot Sequence Swap Floppy Drive Default value is DisabledGate A20 Option Boot Up Floppy SeekBoot Up NumLock Status Default value is On Security Option Chipset Features SetupVideo Bios Shadow Chipset Features ScreenWVideo Off Method Power Management SetupWPower Management WPM Control by APMWReload Global Timer Events WDoze ModeWStandby Mode ROM ISA Bios PCI Slot Configuration Award SOFTWARE, INC PCI Slot ConfigurationPCI/ISA PnP WResources Controlled ByWIRQ n assigned to Legacy ISAIntegrated Peripherals Enter Password Load Setup defaultsPassword Disabled ROM ISA Bios Cmos Setup Utility Award SOFTWARE, INCIDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Flash Memory Writer Utility Screen AwardNMI Timer MAPSystem Resource DMA Channels