Omnitron Systems Technology 10/100M user manual Vlan ID

Page 19

3.4.3Management Processor VLAN Support

The 10/100M Management Processor can independently transmit and receive Management Data with an IEEE 802.1Q tag. To enable and configure this feature, type 9 from the Management Options screen to access the Other Networking Features screen.

Management Options

iConverter, Serial Agent

Network Management

 

1: Chassis and Module Management

 

2:

Set Module Identifier

 

Management Module Preferences

 

3: IP and Control Preferences

 

4:

SNMP Preferences

 

5:

Abandon Preference Changes

 

6:

Save Preference Changes

 

7: Restore to Factory Defaults

 

8:

Restart Management Module

 

9:

Other Networking Features

 

Management Module Maintenance

 

10: Firmware Update

 

11: Set Date/Time

 

IP Address

= 192.168.1.220

 

Chassis Number = 1

 

Enter Choice, (H)elp, E(x)it > 9

 

 

 

 

 

Other Networking Features Screen

iConverter, Serial Agent

1:

Enable/Disable DHCP Client

Disabled

2:

Enable/Disable Keep Alive Trap

Disabled

3:

Keep Alive Trap interval (10-600 secs)

10

4:

Enable/Disable SW1 Switch Block

Enabled

5:

Serial Baud Rate

57600 bps

6:

Enable/Disable VLAN Support

Disabled

7:

VLAN ID (0-4095)

2

8:

VLAN Priority (0-7)

7

Enter Choice, Management Options Screen(0), (H)elp, E(x)it >

To configure the VLAN management ID, select option 7. To configure the priority setting for the VLAN management channel, select option 8. To enable or disable VLAN management support, select option 6.

Once VLAN support is enabled, IP management support will only be accessible using the configured

VLAN ID.

To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.

3.4.4Enabling/Disabling Soft-switch Reload

The Soft-switch Reload function controls the configurations of the 10/100M and other iConverter modules managed by the 10/100M following a power up.

When the Soft-switch Reload is disabled, the configurations of the 10/100M and the other managed modules

Page 19

Image 19
Contents Standalone and PLUG-IN Module Table of Contents Overview Port Structure Installation Procedure Configuring DIP-SWITCHES 1.2 SW2 Fiber Full/Half-Duplex FDX/HDX 1.5 SW5 UTP Full/Half Duplex FDX/HDX These DIP-switches are for factory use only Installing PLUG-IN Modules and Connecting Cables Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting the Chassis Number and Name Setting 10/100M Passwords Setting Snmp Preferences Setting SNMPv1/v2c Read and Write Community Names Setting the Snmp Trap IP Host Addresses Vlan ID Page Access the 10/100M Remotely Updating the 10/100M Firmware via the Serial Console Port Verify Operation NMM Detailed Module Configuration8919-0 10/100M LED UTP HDX UTP FDXModule Management Mode Port Configuration Port Access SFP Information A167EC500000 4 802.3ah Parameters OUI UTP Port Vlan Page Tagged Vlan Pvid BP BBP a UTP BP a BP B Vlan ID VIDVlan Table is Empty Vlan ID +1 Vlan ID CNode Loopback To refresh the Port Statistic screen, press Enter Cable Types 10/100M SpecificationsPossible Causes Troubleshooting GuidePossible Causes Limitation of Warranty Warranty