Utp Hdx Utp Fdx, Led | Omnitron Systems Technology 10/100M instruction

Module -	iConverter 10/100M			iConverter, Serial Agent
Identifier -
Chassis Number		=	1	Switch ON Condition	OFF Condition		H/W	Actual
Slot Number		=	1	1: Pause Enabled	Pause Disabled		Off	Off
Model Number		=	8919-0	2: Fiber HDX	Fiber FDX		Off	Off
				3: UTP Manual	UTP Auto-Neg		Off	Off
Serial Number		= xxxxxxxx		4: UTP 10 Mbps	UTP 100 Mbps		Off	Off
Manufacturing Date = xxxxxxxx				5: UTP HDX	UTP FDX		Off	Off
Product Revision		= x		6: Link Propagate	Link Segment		Off	Off
Software Revision		= xx		7: Remote Fault	Normal		Off	Off
				8: Symm Fault Det	Normal		Off	Off
LED				9: BP A Enabled	BP A Disabled		On	On
1: Power		= On		10: BP B Enabled	BP B Disabled		On	On
2: Power Supply 1		= Off		11: Not Available
3: Power Supply 2		= Off		12: Slave Only	Master/Slave		Off	Off
4: Power Supply 3		= Off		13: Not Available
5: Fiber Link		= Off		14: Not Available
6: BP Master		= On		15: Not Available
7: UTP 10	Link	= Off		16: Not Available
8: UTP 100 Link		= Off		OAM settings:
9: UTP FDX		= Off		17: IP Protocol State		On
				18: Management Mode		Secure OAM
Toggle Switch(1-16), (I)dentifier, (R)eset, (H)elp, (P)ortStat, Port(C)tl >

The Module configuration screen provides general information concerning the configuration and status of the module. The screen displays the model and serial numbers, hardware and software revisions, as well as the condition of the LEDs and DIP-switches. The DIP-switches can be re-configured (options 1 - 10, 12) without removing the module from the chassis. Select the appropriate option to change the DIP-switch setting. Selecting DIP-switch options 1 - 10 and 12, will cause the selection to change states under the ‘Actual’ heading.

NOTE: The Plug-In Module configuration screen is shown. The standalone Module configuration screen will display LED 2, 3, 4, and 6 and DIP-switches 9, 10 and 12 as NOT AVAILABLE.

Page 26

5: UTP HDX

UTP FDX

LED