Omnitron Systems Technology 10/100M user manual Installation Procedure

Page 5

19-Module Chassis

5-Module Chassis

2-Module Chassis

1-Module Redundant Chassis

3.0INSTALLATION PROCEDURE

3.1OVERVIEW

The following steps outline the installation and configuration procedures for the 10/100M. Refer to the specified sections for detailed instructions.

•Configure DIP-switches (Section 3.2)

•Installing the Module and Connecting Cables (Section 3.3)

•Configure Module via Command Line Interface (Section 3.4)

•Verify Operation (Section 3.5)

When the setup and configuration procedures are completed, the 10/100M has been configured with the basic setup requirement for standard operation. To configure the module with additional features, see Section 4.0, “Detailed Module Configuration”.

Page 5

Image 5

Contents Standalone and PLUG-IN Module Table of Contents Overview Port Structure Installation Procedure Configuring DIP-SWITCHES 1.2 SW2 Fiber Full/Half-Duplex FDX/HDX 1.5 SW5 UTP Full/Half Duplex FDX/HDX These DIP-switches are for factory use only Installing PLUG-IN Modules and Connecting Cables Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting the Chassis Number and Name Setting 10/100M Passwords Setting Snmp Preferences Setting SNMPv1/v2c Read and Write Community Names Setting the Snmp Trap IP Host Addresses Vlan ID Page Access the 10/100M Remotely Updating the 10/100M Firmware via the Serial Console Port Verify Operation NMM Detailed Module Configuration8919-0 10/100M LED UTP HDX UTP FDXModule Management Mode Port Configuration Port Access SFP Information A167EC500000 4 802.3ah Parameters OUI UTP Port Vlan Page Tagged Vlan BP a BP BPvid Vlan Table is Empty Vlan ID VIDUTP BP a BP B Vlan ID +1 Vlan ID CNode Loopback To refresh the Port Statistic screen, press Enter Cable Types 10/100M SpecificationsPossible Causes Troubleshooting GuidePossible Causes Limitation of Warranty Warranty