Omnitron Systems Technology 10/100M user manual Detailed Module Configuration, Nmm

Page 24

4.0DETAILED MODULE CONFIGURATION

4.1OVERVIEW

The 10/100M has module parameters that require configuration depending on the application. The Module configuration screen is accessible by selecting the module slot number from the Chassis View screen. To access the Module configuration menu, select 1 at the Management Options screen, press <ENTER>. The Chassis Selection screen will be displayed. From the Chassis Selection screen, select the chassis number where the 10/100M module is installed.

NOTE: Module configuration is also available using NetOutlook.

Chassis Selection

iConverter, Serial Agent

Number

Chassis Name

 

1NMM

2Not Available

3Not Available

4Not Available

5Not Available

6Not Available

7Not Available

8Not Available

9Not Available

10Not Available

11Not Available

12Not Available

13Not Available

14Not Available

15Not Available

16Not Available

17Not Available

18Not Available

19Not Available

Connected to Chassis Number 1

Chassis Number(1-19), Management Options(0), (H)elp, E(x)it > 1

By selecting Chassis Number 1, from the Chassis Selection screen, the Chassis View screen will be displayed.

Page 24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Standalone and PLUG-IN Module Table of Contents Overview Port Structure Installation Procedure Configuring DIP-SWITCHES 1.2 SW2 Fiber Full/Half-Duplex FDX/HDX 1.5 SW5 UTP Full/Half Duplex FDX/HDX These DIP-switches are for factory use only Installing PLUG-IN Modules and Connecting Cables Passwords Management Options screen will be displayed Setting IP and Control Preferences Setting the Chassis Number and Name Setting 10/100M Passwords Setting Snmp Preferences Setting SNMPv1/v2c Read and Write Community Names Setting the Snmp Trap IP Host Addresses Vlan ID Page Access the 10/100M Remotely Updating the 10/100M Firmware via the Serial Console Port Verify Operation Detailed Module Configuration NMM8919-0 10/100M UTP HDX UTP FDX LEDModule Management Mode Port Configuration Port Access SFP Information A167EC500000 4 802.3ah Parameters OUI UTP Port Vlan Page Tagged Vlan BP B PvidBP a Vlan ID VID UTP BP a BP BVlan Table is Empty Vlan ID +1 Vlan ID CNode Loopback To refresh the Port Statistic screen, press Enter 10/100M Specifications Cable TypesTroubleshooting Guide Possible CausesPossible Causes Warranty Limitation of Warranty
Top Page Image Contents