Milan Technology MIL-SM800P, MIL-SM801P, MIL-SM801G manual Attaching Rubber Feet

Page 11

Attaching Rubber Feet

A.Make sure the mounting surface on the bottom of the switch is grease and dust free.

B.Remove adhesive backing from the rubber feet.

C.Apply the rubber feet to each corner on the bottom of the switch. These footpads can protect the switch from shock and vibration.

Figure 2-6. Attaching Rubber Feet to each corner on the bottom of the switch

Power On

Connect the power cord to the power socket on the rear panel of the switch. Connect the other end of the cord to an appropriate power outlet. Check the power indicator on the front panel to see if power is properly supplied. The internal power supply works with AC in the voltage range 100-240VAC, frequency 50~60Hz. Country specific power cords are available for the unit.

7

Image 11

Contents Managed 8 & 9 Port Switches Regulatory Approval Table of Contents Technical Specifications Troubleshooting Introduction Features Package Contents Hardware Description Power 100M LED IndicatorsRear Panel Attaching Rubber Feet Network Application Segment Application Connecting a Terminal or PC to the Console Port Network ConfigurationConsole Menu Settings of communication parametersMain Menu Protocol Related Configuration Configures protocol featuresStatus and Counters Actions Port StatusSystem Information Port CountersAdministration Configuration Switch Static ConfigurationDevice Information IP Configuration Change Username Change PasswordPort / Trunk Configuration Port Mirroring Configuration Vlan Configuration Port Based VLANs Choose a VlanPort Based VLANs IEEE802.1Q VLANs Page Create a Vlan Group Edit / Delete a Vlan Group Priority Configuration Add static MAC address MAC Address Configuration Static MAC AddressDelete static MAC address Edit static MAC addressMisc. Configuration Port Security MAC Age Interval Broadcast Storm Filtering Max Bridge Transmit Delay Bound Protocol Related Configuration 1.STP STP Enable System Configuration STP Port Configuration Snmp System Options Community Strings Trap Managers Lacp GvrpAggregator Setting State Activity Lacp Status Switch Reboot Xmodem Upgrade Root Web ManagementWeb Management Home Overview Port status Single port counter as follows Port StatisticsIP Address AdministratorSwitch Settings Basic Advanced Miscellaneous SettingsPriority Queue Service settings Vlan Operation Mode No Vlan Protocol Enable SettingIgmp Theory of Operation Gvrp Garp Vlan Registration Protocol Console Port Information Trunking Port ControlsAggregator Setting Aggregator Information Message Description Query Filter Database Igmp SnoopingClick on Filter Database Port Security Support Protocol-based Vlan Support Port-based VLANs Ieee 802.1Q VlanVlan Configuration Page Ingress Filtering Configure port VID settingsSettings Port VID Pvid Port VIDPriority Set Spanning TreePort Priority Port Mirroring Snmp Trap Manager Security ManagerWeb management select Administrator-TFTP update firmware Tftp Update FirmwareConfiguration Backup Tftp Restore Configuration Reboot Tftp Backup ConfigurationReset System Specifications Safety WeightHumidity External Power PowerTroubleshooting „ Cabling Page Page Page 90000405 Rev. a