Bryston SP1.7 manual Setting the Speaker Crossover Frequency, Highlight SP Setup Menu

Page 23

1.None: no subwoofer attached to the system.

2.Yes - Xbass Off: subwoofer is active, but only active with LFE tracks if the front speakers are full-range

3.Yes - Xbass On: subwoofer is active in system, in addition to full-range speakers.

NOTE 1: the Xbass settings only show up in the menu if the front speakers are defined as ‘Large’. Otherwise, there are only two options, Yes and None.

NOTE 2: Xtra Bass operation is only available with Stereo, Stereo5, Party, Pro Logic, PLII Music, and PLII Movie modes.

Setting the Speaker Crossover Frequency

1. First enter the main menu by pressing on any one of the menu buttons (< , > or SELECT).

Figure 15: Highlight “SP”

in the Setup Menu

2. Next move the cursor to ‘SP’. Hit ‘SELECT’ - You are now in the Speaker Menu.

Figure 16: Highlight “XO”

in the Speaker Config Menu

21

Image 23

Contents SP1.7 800 632 Bryston 20-YEARWARRANTYContents SP1.7 Functional Layout AccessoriesPower Input Mode PowerStandby and IR Infrared Activity Indicator Front Panel Controls and IndicatorsPower Momentary Switch LCD Display window Using the Dynamic Range ControlMenu Control Buttons Source Selection Buttons and IndicatorsSurround Button Mode Selection ButtonsDigital Mode and Indicator Mono and Mono Downmix Modes Stereo and Stereo Downmix ModeTHX Button Available with THX Listening Mode… Mode ButtonAnalog Balance Master VolumeBypass Button Digital Audio Coaxial Inputs Rear Panel Input and Output ConnectionsBalanced and 2. Unbalanced Outputs Analog InputsTape/Recording Outputs Setting the Optical Audio Input AssignmentToslink Digital Audio Optical Inputs Aux IR Receiver RS-232 connectorRemote 12V Trigger Outputs Programming the AUX Trigger OutputSource Select Buttons SP1.7 Remote ControlIEC Power Connector Fuses Master Power SwitchSetup Buttons Mode Select ButtonsVolume/Trim Buttons Power ButtonPhoto Sensor Status LEDTo accomplish this process the following tools are needed SET UP and Calibration of the SP1.7Setting the Speaker Configuration Explanation of ‘Saved Settings per Source’ FeatureExplanation of ‘Xtra Bass’ Mode Highlight SP Setup Menu Setting the Speaker Crossover FrequencyChange the Crossover Frequency Setting the Channel DelaysSetting Channel Levels without Pink Noise Calibrating and Setting Levels/Channel to Channel BalanceSetting the THX Subwoofer Limiter or Bass Peak Level Manager Setting the Bplm with Pink NoiseEnabling DTS-ES 6.1 Decoding Setting the Bplm without Pink NoiseEnabling THX Surround EX Decoding Hightlight ES Other Settings MenuChange EX Control Setting Changing Dolby Plii Music SettingsHighlight Plii Setup Menu Center Image is a variable in Neo6 music mode only Changing DTS NEO6 SettingsAcknowledgements To change the Center ImageSurround Modes Appendix a SP1.7 Surround ModesPage Table of all available surround modes SignalDTS as per THX licensing agreements Appendix B THX InformationXLR/PHONE Example HOOK-UP DiagramsInputs SP1.7 SpecificationsSuggested Surround Speaker Placement