Bryston SP1.7 manual Front Panel Controls and Indicators, Power Momentary Switch

Page 6

FRONT PANEL CONTROLS AND INDICATORS

Figure 3: Front Panel

When looking at the front panel of the SP1.7 you will see the following

controls and displays from left to right:

1.Power [Momentary Switch]

Toggling this switch up or down takes the unit in and out of its’

Standby power mode.

2.Standby and (IR) Infrared Activity Indicator

If this LED is continuously red, it is an indication that the SP1 is in Standby mode. When the SP1.7 is powered up, the LED is OFF, and flashes (Red) when a valid IR code is detected.

3.(IR) Infrared Receiver/Sensor for remote control

4. Dynamic Range Control

This three position switch permits the adjustment of the dynamic range (softest sound to loudest sound) of signal sources producing a Dolby Digital or DTS encoded bitstream. The Dynamic Range Control has no effect with PCM and Analog input signals.

4

Image 6

Contents SP1.7 Bryston 20-YEARWARRANTY 800 632Contents Accessories SP1.7 Functional LayoutPower Power Input ModeFront Panel Controls and Indicators Power Momentary SwitchStandby and IR Infrared Activity Indicator Using the Dynamic Range Control LCD Display windowSource Selection Buttons and Indicators Menu Control ButtonsMode Selection Buttons Digital Mode and IndicatorSurround Button Stereo and Stereo Downmix Mode Mono and Mono Downmix ModesTHX Button Mode Button Available with THX Listening Mode…Master Volume Bypass ButtonAnalog Balance Analog Inputs Rear Panel Input and Output ConnectionsBalanced and 2. Unbalanced Outputs Digital Audio Coaxial InputsSetting the Optical Audio Input Assignment Toslink Digital Audio Optical InputsTape/Recording Outputs Programming the AUX Trigger Output RS-232 connectorRemote 12V Trigger Outputs Aux IR ReceiverMaster Power Switch SP1.7 Remote ControlIEC Power Connector Fuses Source Select ButtonsPower Button Mode Select ButtonsVolume/Trim Buttons Setup ButtonsStatus LED Photo SensorSET UP and Calibration of the SP1.7 To accomplish this process the following tools are neededExplanation of ‘Saved Settings per Source’ Feature Setting the Speaker ConfigurationExplanation of ‘Xtra Bass’ Mode Setting the Speaker Crossover Frequency Highlight SP Setup MenuSetting the Channel Delays Change the Crossover FrequencyCalibrating and Setting Levels/Channel to Channel Balance Setting Channel Levels without Pink NoiseSetting the Bplm with Pink Noise Setting the THX Subwoofer Limiter or Bass Peak Level ManagerSetting the Bplm without Pink Noise Enabling DTS-ES 6.1 DecodingHightlight ES Other Settings Menu Enabling THX Surround EX DecodingChanging Dolby Plii Music Settings Change EX Control SettingHighlight Plii Setup Menu Changing DTS NEO6 Settings Center Image is a variable in Neo6 music mode onlyTo change the Center Image AcknowledgementsAppendix a SP1.7 Surround Modes Surround ModesPage Signal Table of all available surround modesAppendix B THX Information DTS as per THX licensing agreementsExample HOOK-UP Diagrams XLR/PHONESP1.7 Specifications InputsSuggested Surround Speaker Placement