Lantronix MPS100, LPS1-2, LPS1-T manual Part Number Rev. B

Page 3

The information in this guide may change without notice. The manufacturer assumes no responsibility for any errors which may appear in this guide.

AppleTalk, Chooser, and Macintosh are trademarks of Apple Computer Corporation. LaserJet and Bitronics are trademarks of Hewlett Packard. Centronics is a registered trademark of Centronics Data Computer Corporation. PostScript is a trademark of Adobe Systems, Inc. DEC and LAT are trademarks of Digital Equipment Corporation. Ethernet is a trademark of XEROX Corporation. NetWare is a trademark of Novell Corporation. UNIX is a registered trademark of The Open Group. Windows for Workgroups, Windows 95, Windows 98, Windows 2000, and Windows NT are trademarks of Microsoft Corporation.

Copyright 2000, Lantronix. All rights reserved. No part of the contents of this book may be transmitted or reproduced in any form or by any means without the written permission of Lantronix. Printed in the United States of America.

The revision date for this manual is 23 October, 2000.

Part Number: 900-191

Rev. B

WARNING

This product has been designed to comply with the limits for a Class A digital device pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against such interference when operating in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with this guide, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause interference in which case the user, at his or her own expense, will be required to take whatever measures may be required to correct the interference.

Changes or modifications to this device not explicitly approved by Lantronix will void the user’s authority to operate this device.

Cet appareil doit se soumettre avec la section 15 des statuts et règlements de FCC. Le fonctionnement est subjecté aux conditions suivantes:

(1)Cet appareil ne doit pas causer une interférence malfaisante.

(2)Cet appareil doît accepter n'importé quelle interférence reìue qui peut causer une opération indésirable.

Image 3
Contents For the MPS100, LPS1-T and LPS1-2 Micro Print Servers MPS/LPS Installation GuidePage Part Number Rev. B Page Contents LAT Configuration Specifications Page Introduction How to Use This ManualAppendix F, Frequently-used Commands MPS/LPS Product Description InstallationInstalling the MPS Installation Installing the MPS Page EZWebCon Configuration MethodsIncoming Logins Getting StartedMPSxxxxxxPS LPSxxxxxxPS ServicesMPSxxxxxxTEXT LPSxxxxxxTEXT MPSxxxxxxPCL LPSxxxxxxPCLUsing a Directed Ping Packet TCP/IP ConfigurationSetting the IP Address Using EZWebCon# arp -s 192.0.1.228 00-80-a3-xx-xx-xx % ping Using a BOOTP, DHCP, or Rarp Reply Using the Command Line InterfaceLPR Printing LPR on Windows NT 3.5.1 and later TCP/IP Configuration LPR Printing LPR Printing TCP/IP Configuration LPR on Unix Hosts LPR on Windows 95/988Creating Spooling Directory LPR on AIX HostsPrinters and Plotters window, choose Printers/Plotters LPR on HP HostsLPR on SCO Unix Hosts 11Configuring Remote PrinterRtel Functionality Area to Check Explanation Unix Host TroubleshootingNetWare Configuration Ndps Printing NDS Print QueuesObtain an NDS License Configure your MPS NetWare Administrator Quick Setup Print QueuesPconsole Print Queues From the Menu Bar, select Tools Print Services Quick SetupUse the Show Protocols NetWare Access command. By NetWare Host TroubleshootingCode Meaning Remedy Page Printing Directly to a Port LAT Configuration4Translating LAT Error Codes LAT Host TroubleshootingAppleTalk Zones AppleTalk ConfigurationMacintosh Services BitronicsAppleTalk Host Troubleshooting Host Configuration DLC Configuration for LAN ManagerDLC Configuration MPS ConfigurationSelect Job-based Problem Report Procedure Contact InformationFull Contact Information Page Power-up Troubleshooting TroubleshootingMPS Problem/Message Error RemedyInit Noboot command was Dhcp TroubleshootingRarp Troubleshooting Bootp TroubleshootingPostScript Problems Printing ProblemsBitmap Graphics Entering Commands at the Boot PromptFlash Set Bootp Enabled, DisabledSet Dhcp Enabled, Disabled Flush NVRSet Loadhost ipaddress Set Rarp Enabled, DisabledSet Hardware Set IPAddress ipaddressEthernet Connector Parallel ConnectorsPinouts Page Via FTP Updating SoftwareObtaining Software Via the WebReloading Sequence Reloading SoftwareNetWare Troubleshooting Flash ROM Updates TftpMOP Power Supply Cord TemperatureEnvironmental Limitations Altitude Relative HumidityMax temp. change/hr 20 C 36 F Conventions Frequently-used CommandsServer Commands Define Server Rarp EN/DIS Define Server Privileged PasswordDefine Service Appletalk EN/DIS Define Server Netware LoadhostNoboot Define Service DLC EN/DISDefine Service CancelPort Commands Define Port 1 Flow CTS Define Port 1 Bitronics EN/DISDefine Port 1 Dsrlogout EN/DIS Define Port 1 Dtrwait EN/DISMpsmps Protocol CommandsDefine Proto EN/DIS Define Proto IP EN/DISEncapsulation Etherii Ware AccessDefine Proto Native NetwareWarranty Statement Page Declaration of Conformity Page Index SymbolsMOP Pconsole FTP D-1
Related manuals
Manual 100 pages 51.23 Kb