Lantronix LPS1-2, MPS100 manual Define Port 1 Bitronics EN/DIS, Define Port 1 Dsrlogout EN/DIS, Xon

Port Commands		Frequently-used Commands
	Table F-2:Port Commands, cont.
Command	Option(s)	Description
DEFINE PORT 1 BITRONICS {EN/DIS}		When Enabled, ensures bidirectional functioning of
		the parallel port. The attached printer must also sup-
		port Bitronics mode.
DEFINE PORT 1 CHARACTER size		Toggles the port between 7-bit and 8-bit characters
		(the default). Enter either 7 or 8.
DEFINE PORT 1 DSRLOGOUT {EN/DIS}		When Enabled, the port will be logged out automat-
		ically whenever DSR is deasserted.
DEFINE PORT 1 DTRWAIT {EN/DIS}		When Enabled, the MPS will not assert DTR on the
		port when it is idle (no user logins or connections).
DEFINE PORT 1 FLOW	CTS	Specifies CTS/RTS (hardware) flow control.
option
	{EN/DIS}	Activates or deactivates the currently-configured
		flow-control method.
	NONE	Removes the current flow control settings.
	XON	Specifies XON/XOFF (software) flow control.
DEFINE PORT 1 NAME “newname”		Enter a name of up to 16 alphanumeric characters
		for the specified port.
DEFINE PORT 1	parity	Enter even, odd, mark, or space. Specifying mark
PARITY option		or space will change the character size to 7 bits.
	NONE	Specifies that no parity will be used (the default).
DEFINE PORT 1 SPEED baudnum		Sets the port’s baud rate. Acceptable baudnum val-
		ues range from 300 to /230000 (MPS)baud.
{SHOW/MONITOR} PORT 1		Displays the port’s configuration characteristics
		once (Show) or continually every three seconds
		(Monitor). Counters and Status keywords can be
		added.
TEST PORT 1 option	COUNT rows	Sends an ASCII data stream to the port for the spec-
	WIDTH cols	ified number of rows and/or columns.
	POSTSCRIPT	Sends a PostScript test page to the port.

F-6