LevelOne WBR-3404TX user manual Reset

Page 10

Port:

RESET

To reset system settings to factory defaults, please follow the steps:

1.Power off the device,

2.Press the reset button and hold,

3.Power on the device,

4.Keep the button pressed about 5 seconds,

5.Release the button,

6.Watch the STATUS LED, they will flash 8 times and then STATUS flash once per second.

10

Image 10

Contents LevelOne Copyright TrademarksFCC Interference Statement CE Declaration of ConformityTable of Contents Firmware Upgrade Functions and Features User-Definable Application Sensing Tunnel Universal Plug and Play UPnP supportedVirtual Server supported DMZ Host supported802.1X supported Packing ListPanel Layout Front PanelUSB Reset Decide where to place your Wireless Broadband Router Procedure for Hardware InstallationRear Panel Connecting this product with your printer Setup LAN connectionSetup WAN connection Power onMake Correct Network Settings of Your Computer Install the Software into Your ComputersPage Page Page Configuring LevelOne WBR-3404TX Start-up and LogStatus Wizard Page Basic Setting Primary Setup WAN Type, Virtual Computers Press Change Static IP Address Dynamic IP AddressPPP over Ethernet PptpPage Virtual Computers Dhcp Server Press MorePage Wireless Setting, and 802.1X setting Radius Server 802.1XEncryption Key Length Radius Shared KeyChange Password Forwarding Rules Virtual Server Special AP IP Address of DMZ Host UPnP SettingMiscellaneous Items Non-standard FTP portSecurity Settings Packet Filter Inbound Filter ExampleThey can do everything block nothing Others are all blocked Example Page Domain Filter Example URL Blocking Enable URL BlockingPage MAC Address Control MAC Address Control tableIP Address ∙ Tunnel name VPN setting∙ Max. number of tunnels item ∙ MethodBasic setup Local subnet ∙VPN Settings IKEFunction of Buttons Remote netmask Local netmaskRemote subnet Remote gateway∙VPN Settings Set IKE Proposal IPSec Proposal index ∙VPN Settings -Set IPSec ProposalEncapsulation protocol IPSec proposal Administrator Time-out Remote Administrator Host/PortDiscard Ping from WAN side Advanced Setting Time Server System TimeGet Date and Time by NTP Protocol Time ZoneIP Address for Syslog Mail Alert EnableSystem Log Smtp Server IP and PortDynamic DNS Mail SubjectExample Get Community Snmp SettingEnable Snmp Set CommunityPage Routing Table Page Toolbox You can View system log by clicking the View Log button Firmware Upgrade Reset to default Backup SettingReboot MAC Address for Wake-on-LAN Domain Name or IP address for Ping TestConfiguring on Windows 95/98 Platforms Print ServerPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Select Ports page, Click Add Port… Page Select Custom, then click Settings… Page Apply your settings Page Configuring on Unix based Platforms Appendix a TCP/IP Configuration for Windows 95/98 Install TCP/IP Protocol into Your PCSet TCP/IP Protocol for Working with NAT Router Page Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page