LevelOne WBR-3404TX user manual Setup LAN connection, Setup WAN connection, Power on

Page 12

2.Setup LAN connection

a.Wired LAN connection: connects an Ethernet cable from your computer’s Ethernet port to one of the LAN ports of this product.

b.Wireless LAN connection: locate this product at a proper position to gain the best transmit performance.

Figure 2-3 Setup of LAN and WAN connections for this product.

3. Setup WAN connection

Prepare an Ethernet cable for connecting this product to your cable/xDSL modem or Ethernet backbone. Figure 2-3 illustrates the WAN connection.

4. Connecting this product with your printer

Use the printer cable to connect your printer to the printer port of this product.

5. Power on

Connecting the power cord to power inlet and turning the power switch on, this product will automatically enter the self-test phase. When it is in the self-test phase, the indicators STATUS will be lighted ON for about 10 seconds, and then STATUS will be flashed 3 times to indicate that the self-test operation has finished. Finally, the STATUS will be continuously flashed once per second to indicate that this product is in normal operation.

12

Image 12

Contents LevelOne Copyright TrademarksFCC Interference Statement CE Declaration of ConformityTable of Contents Firmware Upgrade Functions and Features Universal Plug and Play UPnP supported Virtual Server supportedUser-Definable Application Sensing Tunnel DMZ Host supportedPacking List Panel Layout802.1X supported Front PanelUSB Reset Procedure for Hardware Installation Decide where to place your Wireless Broadband RouterRear Panel Setup LAN connection Setup WAN connectionConnecting this product with your printer Power onMake Correct Network Settings of Your Computer Install the Software into Your ComputersPage Page Page Configuring LevelOne WBR-3404TX Start-up and LogStatus Wizard Page Basic Setting Primary Setup WAN Type, Virtual Computers Press Change Static IP Address Dynamic IP AddressPPP over Ethernet PptpPage Virtual Computers Dhcp Server Press MorePage Wireless Setting, and 802.1X setting 802.1X Encryption Key LengthRadius Server Radius Shared KeyChange Password Forwarding Rules Virtual Server Special AP UPnP Setting Miscellaneous ItemsIP Address of DMZ Host Non-standard FTP portSecurity Settings Packet Filter Inbound Filter ExampleThey can do everything block nothing Others are all blocked Example Page Domain Filter Example URL Blocking Enable URL BlockingPage MAC Address Control Control table MAC AddressIP Address VPN setting ∙ Max. number of tunnels item∙ Tunnel name ∙ Method∙VPN Settings IKE Basic setup Local subnetFunction of Buttons Local netmask Remote subnetRemote netmask Remote gateway∙VPN Settings Set IKE Proposal ∙VPN Settings -Set IPSec Proposal IPSec Proposal indexEncapsulation protocol IPSec proposal Remote Administrator Host/Port Administrator Time-outDiscard Ping from WAN side Advanced Setting System Time Get Date and Time by NTP ProtocolTime Server Time ZoneMail Alert Enable System LogIP Address for Syslog Smtp Server IP and PortDynamic DNS Mail SubjectExample Snmp Setting Enable SnmpGet Community Set CommunityPage Routing Table Page Toolbox You can View system log by clicking the View Log button Firmware Upgrade Backup Setting Reset to defaultReboot MAC Address for Wake-on-LAN Domain Name or IP address for Ping TestConfiguring on Windows 95/98 Platforms Print ServerPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Select Ports page, Click Add Port… Page Select Custom, then click Settings… Page Apply your settings Page Configuring on Unix based Platforms Appendix a TCP/IP Configuration for Windows 95/98 Install TCP/IP Protocol into Your PCSet TCP/IP Protocol for Working with NAT Router Page Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page