LevelOne WBR-3404TX user manual

Page 63

So if, for example, the host wanted to send an IP data gram to 192.168.3.88, it would use the above table to determine that it had to go via 192.168.1.33 (a gateway),

And if it sends Packets to 192.168.5.77 will go via 192.168.1.55

Each rule can be enabled or disabled individually.

After routing table setting is configured, click the save button.

63

Image 63
Contents LevelOne Trademarks CopyrightCE Declaration of Conformity FCC Interference StatementTable of Contents Firmware Upgrade Functions and Features DMZ Host supported Universal Plug and Play UPnP supportedVirtual Server supported User-Definable Application Sensing TunnelFront Panel Packing ListPanel Layout 802.1X supportedUSB Reset Procedure for Hardware Installation Decide where to place your Wireless Broadband RouterRear Panel Power on Setup LAN connectionSetup WAN connection Connecting this product with your printerInstall the Software into Your Computers Make Correct Network Settings of Your ComputerPage Page Page Start-up and Log Configuring LevelOne WBR-3404TXStatus Wizard Page Basic Setting Primary Setup WAN Type, Virtual Computers Press Change Dynamic IP Address Static IP AddressPptp PPP over EthernetPage Virtual Computers Press More Dhcp ServerPage Wireless Setting, and 802.1X setting Radius Shared Key 802.1XEncryption Key Length Radius ServerChange Password Forwarding Rules Virtual Server Special AP Non-standard FTP port UPnP SettingMiscellaneous Items IP Address of DMZ HostSecurity Settings Packet Filter Example Inbound FilterThey can do everything block nothing Others are all blocked Example Page Domain Filter Example URL Blocking URL Blocking EnablePage MAC Address Control Control table MAC AddressIP Address ∙ Method VPN setting∙ Max. number of tunnels item ∙ Tunnel name∙VPN Settings IKE Basic setup Local subnetFunction of Buttons Remote gateway Local netmaskRemote subnet Remote netmask∙VPN Settings Set IKE Proposal ∙VPN Settings -Set IPSec Proposal IPSec Proposal indexEncapsulation protocol IPSec proposal Remote Administrator Host/Port Administrator Time-outDiscard Ping from WAN side Advanced Setting Time Zone System TimeGet Date and Time by NTP Protocol Time ServerSmtp Server IP and Port Mail Alert EnableSystem Log IP Address for SyslogMail Subject Dynamic DNSExample Set Community Snmp SettingEnable Snmp Get CommunityPage Routing Table Page Toolbox You can View system log by clicking the View Log button Firmware Upgrade Backup Setting Reset to defaultReboot Domain Name or IP address for Ping Test MAC Address for Wake-on-LANPrint Server Configuring on Windows 95/98 PlatformsPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Select Ports page, Click Add Port… Page Select Custom, then click Settings… Page Apply your settings Page Configuring on Unix based Platforms Install TCP/IP Protocol into Your PC Appendix a TCP/IP Configuration for Windows 95/98Set TCP/IP Protocol for Working with NAT Router Page Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page