LevelOne WBR-3404TX user manual Functions and Features

Page 6

Chapter 1 Introduction

Congratulations on your purchase of LevelOne WBR-3404TXWireless Broadband Router. This product is specifically designed for Small Office and Home Office needs. It provides a complete SOHO solution for Internet surfing, and is easy to configure and operate even for non-technical users. Instructions for installing and configuring this product can be found in this manual. Before you install and use this product, please read this manual carefully for fully exploiting the functions of this product.

Functions and Features

High speed for wireless LAN connection

Up to 54Mbps data rate by incorporating Orthogonal Frequency Division Multiplexing (OFDM).

Roaming

Provides seamless roaming within the IEEE 802.11b(11M) and IEEE 802.11g(54M) WLAN infrastructure.

IEEE 802.11b compatible(11M)

Allowing inter-operation among multiple vendors.

IEEE 802.11g compatible(54M)

Allowing inter-operation among multiple vendors.

Auto fallback

54M, 48M, 36M, 24M, 18M, 12M, 6M data rate with auto fallback in 802.11g mode. 11M, 5.5M, 2M, 1M data rate with auto fallback in 802.11b mode

Broadband modem and NAT Router

Connects multiple computers to a broadband (cable or DSL) modem or an Ethernet router to surf the Internet.

Auto-sensing Ethernet Switch

Equipped with a 4-port auto-sensing Ethernet switch.

VPN supported

Supports multiple PPTP sessions and allows you to setup VPN server and VPN clients.

Printer sharing

Embeds a print server to allow all of the networked computers to share one printer. Built-in USB host to connect to USB printer for printer sharing

Firewall

All unwanted packets from outside intruders are blocked to protect your Intranet.

DHCP server supported

All of the networked computers can retrieve TCP/IP settings automatically from this product.

Web-based configuring

Configurable through any networked computers web browser using Netscape or Internet Explorer.

Packet filter supported

6

Image 6
Contents LevelOne Copyright TrademarksFCC Interference Statement CE Declaration of ConformityTable of Contents Firmware Upgrade Functions and Features User-Definable Application Sensing Tunnel Universal Plug and Play UPnP supportedVirtual Server supported DMZ Host supported802.1X supported Packing ListPanel Layout Front PanelUSB Reset Procedure for Hardware Installation Decide where to place your Wireless Broadband RouterRear Panel Connecting this product with your printer Setup LAN connectionSetup WAN connection Power onMake Correct Network Settings of Your Computer Install the Software into Your ComputersPage Page Page Configuring LevelOne WBR-3404TX Start-up and LogStatus Wizard Page Basic Setting Primary Setup WAN Type, Virtual Computers Press Change Static IP Address Dynamic IP AddressPPP over Ethernet PptpPage Virtual Computers Dhcp Server Press MorePage Wireless Setting, and 802.1X setting Radius Server 802.1XEncryption Key Length Radius Shared KeyChange Password Forwarding Rules Virtual Server Special AP IP Address of DMZ Host UPnP SettingMiscellaneous Items Non-standard FTP portSecurity Settings Packet Filter Inbound Filter ExampleThey can do everything block nothing Others are all blocked Example Page Domain Filter Example URL Blocking Enable URL BlockingPage MAC Address Control Control table MAC AddressIP Address ∙ Tunnel name VPN setting∙ Max. number of tunnels item ∙ Method∙VPN Settings IKE Basic setup Local subnetFunction of Buttons Remote netmask Local netmaskRemote subnet Remote gateway∙VPN Settings Set IKE Proposal ∙VPN Settings -Set IPSec Proposal IPSec Proposal indexEncapsulation protocol IPSec proposal Remote Administrator Host/Port Administrator Time-outDiscard Ping from WAN side Advanced Setting Time Server System TimeGet Date and Time by NTP Protocol Time ZoneIP Address for Syslog Mail Alert EnableSystem Log Smtp Server IP and PortDynamic DNS Mail SubjectExample Get Community Snmp SettingEnable Snmp Set CommunityPage Routing Table Page Toolbox You can View system log by clicking the View Log button Firmware Upgrade Backup Setting Reset to defaultReboot MAC Address for Wake-on-LAN Domain Name or IP address for Ping TestConfiguring on Windows 95/98 Platforms Print ServerPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Select Ports page, Click Add Port… Page Select Custom, then click Settings… Page Apply your settings Page Configuring on Unix based Platforms Appendix a TCP/IP Configuration for Windows 95/98 Install TCP/IP Protocol into Your PCSet TCP/IP Protocol for Working with NAT Router Page Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page