LevelOne WBR-3404TX user manual ∙VPN Settings -Set IPSec Proposal, IPSec Proposal index

Page 52

∙VPN Settings -Set IPSec Proposal

IPSec Proposal index

A list of selected proposal indexes from the IPSec proposal pool listed below. The selecting activity is performed by selecting a proposal ID and clicking "add to" button in the bottom of the page. There are only four indexes can be chosen for the dedicated tunnel. Remove button beside the index list can remove selected proposal index before.

Proposal name

It indicates which IPSec proposal to be focused. First char of the name with 0x00 value stands for the proposal is not available.

∙DH group

There are three groups can be selected: group 1 (MODP768), group 2 (MODP1024), group 5 (MODP1536). But none also can be selected here for IPSec proposal.

Encapsulation protocol

There are two protocols can be selected: ESP and AH.

Encryption algorithm

There are two algorithms can be selected: 3DES and DES. But when the encapsulation protocol is AH, encryption algorithm is unnecessarily set.

Authentication algorithm

There are two algorithms can be selected: SHA1 and MD5. But none also can be selected here for

52

Image 52

Contents LevelOne Copyright TrademarksFCC Interference Statement CE Declaration of ConformityTable of Contents Firmware Upgrade Functions and Features Universal Plug and Play UPnP supported Virtual Server supportedUser-Definable Application Sensing Tunnel DMZ Host supportedPacking List Panel Layout802.1X supported Front PanelUSB Reset Decide where to place your Wireless Broadband Router Procedure for Hardware InstallationRear Panel Setup LAN connection Setup WAN connectionConnecting this product with your printer Power onMake Correct Network Settings of Your Computer Install the Software into Your ComputersPage Page Page Configuring LevelOne WBR-3404TX Start-up and LogStatus Wizard Page Basic Setting Primary Setup WAN Type, Virtual Computers Press Change Static IP Address Dynamic IP AddressPPP over Ethernet PptpPage Virtual Computers Dhcp Server Press MorePage Wireless Setting, and 802.1X setting 802.1X Encryption Key LengthRadius Server Radius Shared KeyChange Password Forwarding Rules Virtual Server Special AP UPnP Setting Miscellaneous ItemsIP Address of DMZ Host Non-standard FTP portSecurity Settings Packet Filter Inbound Filter ExampleThey can do everything block nothing Others are all blocked Example Page Domain Filter Example URL Blocking Enable URL BlockingPage MAC Address Control MAC Address Control tableIP Address VPN setting ∙ Max. number of tunnels item∙ Tunnel name ∙ MethodBasic setup Local subnet ∙VPN Settings IKEFunction of Buttons Local netmask Remote subnetRemote netmask Remote gateway∙VPN Settings Set IKE Proposal IPSec Proposal index ∙VPN Settings -Set IPSec ProposalEncapsulation protocol IPSec proposal Administrator Time-out Remote Administrator Host/PortDiscard Ping from WAN side Advanced Setting System Time Get Date and Time by NTP ProtocolTime Server Time ZoneMail Alert Enable System LogIP Address for Syslog Smtp Server IP and PortDynamic DNS Mail SubjectExample Snmp Setting Enable SnmpGet Community Set CommunityPage Routing Table Page Toolbox You can View system log by clicking the View Log button Firmware Upgrade Reset to default Backup SettingReboot MAC Address for Wake-on-LAN Domain Name or IP address for Ping TestConfiguring on Windows 95/98 Platforms Print ServerPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Select Ports page, Click Add Port… Page Select Custom, then click Settings… Page Apply your settings Page Configuring on Unix based Platforms Appendix a TCP/IP Configuration for Windows 95/98 Install TCP/IP Protocol into Your PCSet TCP/IP Protocol for Working with NAT Router Page Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page