QUICKSTART GUIDE
A valid IP address and subnet mask can now be programmed into the Switch using the IP config command as follows:
ZType in “ipconfig ip=“.
ZEnter the IP address (in our example we will use a unique address between 3.94.247.1 and 3.94.247.254), followed by a space.
ZType in “mask=“ and enter the mask (in our example system we would use 255.255.252.0).
ZIf a default gateway is also required enter a space and type “dgw=“
ZEnter the IP address of the gateway, then select the enter key. The switch will then indicate that the parameters have been set.
ZSave the settings using the Save command.
UR SWITCH MODULE – QUICKSTART GUIDE |