GE QS24 UR quick start You have completed configuration of Ring-only mode

Page 52

QUICKSTART GUIDE

FIGURE QS–16: Configuration of the UR Switch Ring-only mode

You have completed configuration of Ring-only mode.

QS–48

UR SWITCH MODULE – QUICKSTART GUIDE

Image 52

Contents UR Switch Module Ethernet Communications GE MultilinGE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-2 QS-1 Twisted Pair copper cable FiberQS.1.2 Supported Network Topologies Star ArchitectureMesh Architecture Ring ArchitectureUnshielded Twisted Pair cable Ethernet Unshielded Twisted PairQS-5 QS-6 QS.3.1 Fiber Optic Ethernet Wavelengths of lightFiber Cable Cross Section and Physical Specifications Multi ModeSingle Mode QS.3.2 Single and Multi-mode cableQS.3.3 Optical Power Budget Difference between Single-mode and Multi-mode CableFigure QS-4 Common Fiber Optic Connectors QS.3.4 Maximum fiber segment length calculation QS.3.5 UR-2S and UR-2T 10/100 BaseT Switch Ports Maximum 10 Mbps Ethernet Segment LengthsQS.4 Introduction to the 2S and 2T UR Managed Switch Modules Figure QS-5 Traditional Redundant UR LAN Topology QS.4.2 2S and 2T LED indicators QS.4.1 Hardware OverviewQS.4.3 Hardware Installation T60 Transformer Management RelayQS.4.4 initial Configuration Procedure AC or DCQS-18 DB9 Female to DB9 Female Cable Pin-out QS-20 QS-21 QS-22 QS-23 Type in ipconfig ip= QS-25 QS.4.7 Assigning a static IP Address to a personnel computer Select PropertiesRight mouse click on the Local Area Connections icon Select Use the following IP address Addresses now being used QS-30 QS.4.8 Self-test Errors and Meaning Function Module OfflineEquipment QS.5 Tagged VLAN’s BackgroundQS.5.1 Configuring Tagged VLANs Configuring a Vlan within the SwitchSave We have now configured the Switch to support Tag-based VLANs QS-37 Configure You have now completed the exercise QS.5.2 Configuring the UR Switch for Ring Only Mode Figure QS-15 Configuration of UR Switch Ring-only ModeQS-41 Select Bridge Rstp Then Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status For Every Switch RING, Disable LLA on Ports That are Ring You have completed configuration of Ring-only mode Figure QS-16 Configuration of the UR Switch Ring-only modeQS.5.3 Saving and Loading Switch Settings Saving Switch SettingsLoading Switch Settings Select the Retrieve Switch Settings Files optionQS-50 QS.6.2 Selecting the Proper Version QS.6.1 Updating UR Switch Module FirmwareVersion 2.1beta QS-52 QS-53 QS-54