GE QS24 UR quick start Then Save Enable Status

Page 47

QUICKSTART GUIDE

ZOnce in Edit mode, change the Status to Enabled

ZOnce these settings have been completed Save the configuration.

...THEN SAVE

ENABLE STATUS...

UR SWITCH MODULE – QUICKSTART GUIDE

QS–43

Image 47

Contents GE Multilin UR Switch Module Ethernet CommunicationsGE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-2 QS-1 Fiber Twisted Pair copper cableRing Architecture QS.1.2 Supported Network TopologiesStar Architecture Mesh ArchitectureEthernet Unshielded Twisted Pair Unshielded Twisted Pair cableQS-5 QS-6 Wavelengths of light QS.3.1 Fiber Optic EthernetQS.3.2 Single and Multi-mode cable Fiber Cable Cross Section and Physical SpecificationsMulti Mode Single ModeDifference between Single-mode and Multi-mode Cable QS.3.3 Optical Power BudgetFigure QS-4 Common Fiber Optic Connectors QS.3.4 Maximum fiber segment length calculation Maximum 10 Mbps Ethernet Segment Lengths QS.3.5 UR-2S and UR-2T 10/100 BaseT Switch PortsQS.4 Introduction to the 2S and 2T UR Managed Switch Modules Figure QS-5 Traditional Redundant UR LAN Topology QS.4.1 Hardware Overview QS.4.2 2S and 2T LED indicatorsT60 Transformer Management Relay QS.4.3 Hardware InstallationAC or DC QS.4.4 initial Configuration ProcedureQS-18 DB9 Female to DB9 Female Cable Pin-out QS-20 QS-21 QS-22 QS-23 Type in ipconfig ip= QS-25 Select Properties QS.4.7 Assigning a static IP Address to a personnel computerRight mouse click on the Local Area Connections icon Select Use the following IP address Addresses now being used QS-30 Function Module Offline QS.4.8 Self-test Errors and MeaningEquipment Background QS.5 Tagged VLAN’sConfiguring a Vlan within the Switch QS.5.1 Configuring Tagged VLANsSave We have now configured the Switch to support Tag-based VLANs QS-37 Configure You have now completed the exercise Figure QS-15 Configuration of UR Switch Ring-only Mode QS.5.2 Configuring the UR Switch for Ring Only ModeQS-41 Select Bridge Rstp Then Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status For Every Switch RING, Disable LLA on Ports That are Ring Figure QS-16 Configuration of the UR Switch Ring-only mode You have completed configuration of Ring-only modeSelect the Retrieve Switch Settings Files option QS.5.3 Saving and Loading Switch SettingsSaving Switch Settings Loading Switch SettingsQS-50 Version 2.1beta QS.6.1 Updating UR Switch Module FirmwareQS.6.2 Selecting the Proper Version QS-52 QS-53 QS-54