Enterasys Networks A2H124-48P, A2H124-24P manual Connecting AC and PoE Power, AC Power

Connecting AC and PoE Power

Connecting AC and PoE Power

AC Power

Note: The power supply in the switch has automatic voltage sensing that allows connection to power sources ranging from 100 to 240 VAC.

To connect a switch to the AC power source, refer to Figure 3‐6 and proceed as follows:

1.Plug the power cord into the switch AC power connector.

2.Plug the other end of the power cord into a dedicated grounded AC outlet (not shown). The type of power outlet and power cord are country‐dependent.

Note: If you plan to connect all the switches quickly to allow automatic Manager selection, wait until all switches are fully operational before proceeding to the next step.

If you plan to power up each switch and allow it to become fully operational before applying power to the next switch, proceed to the next step.

Figure 3-6 Switch Rear View (A2H124-48P shown)

105.1A500-C-A2406LIN0MHzCVEA

AX.

Á

RDeCduLinndean12tVPowerS /13AuppMly AX.

Â

M
ACADD
RESS	SERIAL NO.

À

AC			LINE
100-
		240
50-					VAC
1			60
5.					Hz
	A
				MAX.

1 AC power cord 2 AC power connector 3 Connector for external redundant power supply

3-12 Hardware Installation