Connecting to Console Port for Local Management
What Is Needed
The following is a list of user‐supplied DTE interface cables that may be needed to connect the DB9 male Console port connector on the switch. The cables are terminated by a DB9 female connector at one end, and by one of three type connectors at the other end, depending on the type connection needed for the remote device. The cables that may be needed are as follows:
•DB9 female‐to‐DB9 female
•DB9 female‐to‐DB25 female
•DB9 female‐to‐DB25 male
Using a DTE modem DB9 female‐to‐DB9 female cable, you can connect products equipped with a DB9 DTE male console port to an IBM or compatible PC running a VT series emulation software package.
Using a DTE modem DB9 female‐to‐DB25 female cable, you can connect products equipped with a DB9 DTE male console port to a VT series terminal or VT type terminals running emulation programs for the VT series.
Using a DTE modem DB9 female‐to‐DB25 male cable, you can connect products equipped with a DB9 DTE male console port to a Hayes compatible modem that supports
9600 baud.
The cable used must connect the Console port Received Data, Pin 2 to the Transmitted Data pin at the other end of the cable. The connection from the Console port Transmitted Data, Pin 3 must be connected to the Received Data pin cable connection at the other end of the cable. The DB9 Console port pin assignments are shown in Figure 3‐8.
Figure 3-8 DB9 Male Console Port Pinout Assignments
3 |
|
| 1 | Pin 2, Received Data (input) |
| 5 |
| 2 | Pin 3, Transmitted Data (output) |
| 9 | 3 | Pin 5, Signal Ground | |
2 |
| |||
|
|
| All other pins not connected. | |
1 | 1 | 6 |
|
|
SecureStack A2 PoE Installation Guide